5 DIY Water Damage Restoration Tips for Your Home

1. 5 DIY Water Damage Restoration Tips for 5 DIY Water Damage Restoration Tips for Your Home Your Home Now that you have properly assessed the situation, consider these water damage restoration tips to ensure repairs are done quickly. It is important to note that wet materials begin to develop mold after 24 hours, so you don’t have time to wait! 1.Disconnect Outlets The first thing to do when you discover water damage in your home is to unplug all electronics immediately. While you may not see the severity of the water damage just yet, it’s important to be cautious around appliances and gas lines. Using this equipment despite the situation could cause electrical shocks or even explosions. 2. Inspect Mold Certain mold strains are toxic to humans and pose serious health risks. Most of the time, mold can spread quickly once it infests an area, so it is in your best interest to inspect for growth to avoid any health hazards. For small issues, you can cut out the affected area, bag it, and dispose of it immediately. However, with serious mold infestations, you need to shut down any airflow to stop contamination and then call a mold specialist. Oftentimes, mold can appear inside the walls or floors, so it’s important that this inspection is ongoing throughout the restoration. 3. Dry Water Out Before more damage occurs, you need to eliminate all moisture and dry out the affected areas. You can use fans or a large-capacity dehumidifier to circulate air and dry out the carpet, wood, and other surrounding materials. While this won’t prevent mold growth altogether, properly drying out the area will help lessen the damage. 4. Remove Damaged Materials If your porous materials, like insulation or carpet, are soaked with water, you need to dispose of them immediately to avoid mildew. It is important to focus on the ceiling and floors first. This means unsealed cement, drywall, and wood need to be addressed and replaced so the home’s structure can support water damage repair. 5. Disinfect Remaining Areas

2. Depending on the type of water you are dealing with, it can contain a lot of bacteria and other hazards that can cause health problems. The water could also encourage the growth of mold, so it is important to sanitize immediately. Once the damaged materials have been removed, you will want to disinfect the entire area before you begin the restoration process. Spray and wipe down the surfaces with bleach so the mold spores don’t grow before you continue with the repairs. For more Contact on 0480 030 780 or Schedule your Appointment for Water or Flood Damage Restoration with Emergency Flood Restoration Sydney today!