1 / 32

TRANASMISSION

TRANASMISSION. TRANSMISSION…. Transportation of information (Data) from Source (Tx) to Destination (Rx). Media. Tx. Rx. Media: Copper OFC Satellite Microwave (Radio). A Radio Link ….

clifford-bryant
Download Presentation

TRANASMISSION

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. TRANASMISSION Network Services :Transmission Planning

  2. TRANSMISSION… Transportation of information (Data) from Source (Tx) to Destination (Rx). Media Tx Rx Media: • Copper • OFC • Satellite • Microwave (Radio) Network Services :Transmission Planning

  3. A Radio Link … • The fundamental aim of a radio link isto deliver sufficient signal power to the receiverat the far end of the linkto achieve some performance objective. • For a data transmission system, thisobjective isusually specified as aminimum bit error rate (BER). • In the receiver demodulator, theBER is a function of the signal to noise ratio (SNR). • At the frequencies under consideration here, the noise power is often dominated by theinternal receiver noise; however, this is not always the case, especially at the lower (VHF) end of the range. Network Services :Transmission Planning

  4. In addition, the “noise” may also include significant power frominterfering signals, necessitating the delivery of higher signal power to the receiver than would be the case under more ideal circumstances (i.e., back-to-back through an attenuator). If the channel containsmultipath,this may also have a major impact on the BER. … Let us focus on predicting the signal power which will be available to the receiver… Network Services :Transmission Planning

  5. RADIO RELAY LINK… Branching Loss FSL Branching Loss ODU ODU Atmospheric Loss Tx/Rx (IDU) Tx/Rx (IDU) + Gt + Gr - Lr - Lt Rx Pt Network Services :Transmission Planning

  6. The benchmark by which we measure the loss in a transmission link is the loss that would be expected in free space - in other words, the loss that would occur in a region which is free of all objects that might absorb or reflect radio energy. And mathematically, FREE SPACE LOSSis expressed as: FSL (dB) = 32.4 + 20*LOG(f) + 20*LOG(D) Where, f : Frequency of Operation, in MHz D: Hop length, in Km OR, FSL (dB) = 92.45 + 20*LOG(f) + 20*LOG(D) Where, f : Frequency of Operation, in GHz D: Hop length, in Km Network Services :Transmission Planning

  7. A Real Radio Relay System… Of course, in looking at a real system, we must consider the actual antenna gains and cable losses in calculating the signal power Pr which is available at the receiver input: Network Services :Transmission Planning

  8. Path Loss on Line of Sight Links… Line of Sight (LOS):the antennas at the ends of the link can “see” each other, at least in a radio sense. In many cases,radio LOS equates to optical LOS:you’re at the location of the antenna at one end of the link, and with the unaided eye or binoculars, you can see the antenna (or its future site) at the other end of the link. In other cases,we may still have an LOS path even though we can’t see the other end visually: This is because the radio horizon extends beyond the optical horizon. Radio waves follow slightly curved paths in the atmosphere, but if there is a direct path between the antennas which doesn’t pass through any obstacles, then we still have radio LOS. Optical LOS Radio LOS Optical LOS Does having LOS mean that the path loss will be equal to the free space case which we have just considered? In some cases, the answer is yes, but it is definitely not a sure thing. There arethreemechanisms which may cause the path loss to differ from the free spacecase: • Refraction in the earth’s atmosphere, which alters the trajectory of radio waves, and which can change with time. Network Services :Transmission Planning

  9. Diffractioneffects resulting from objects near the direct path. • Reflectionsfrom objects, which may be either near or far from the direct path. Atmospheric Refraction : Under normal circumstances, the index of refraction decreases monotonically with increasing height (gaseous density decreases with increasing altitude), which causes the radio waves emanating from the transmitter to bend slightly downwards towards the earth’s surface instead of following a straight line. Under normal conditions, the gradient in refractivity index is such that real world propagation is equivalent to straight-line propagation over an earth whose radius is greater than the real one by a factor of 4/3 - thus the often-heard term “4/3 earth radius” in discussions of terrestrial propagation. Network Services :Transmission Planning

  10. Insuperrefraction, the rays bend more than normal and the radio horizon is extended – Ducting. Insubrefraction, in which the bending of the rays is less than normal, thus shortening the radio horizon and reducing the clearance over obstacles along the path. This may lead to increased path loss, and possibly even an outage. Super-refraction ( Temp Inversion) Network Services :Transmission Planning

  11. Hyper-refraction( K> 4/3) Normal-refraction ( K= 4/3) Sub-refraction K < 4/3) 0-3 Power Density dB 0-2 0-1 0 1 02 03 Approx. 6 dB Loss at the grazing Object Position DIFFRACTION O B S T A C L E P Network Services :Transmission Planning

  12. A Fresnel zone: it is the volume of space enclosed by an ellipsoid which has the two antennas at the ends of a radio link at its foci. The two-dimensional representation of a Fresnel zone : d d2 d1 Direct Path : AB, the actual Hop Length d Diffracted Path : ACB = d1 + d2 (ACB) – (AB ) = Path Difference =D D= nl/2, For the first Fresnel zone, n = 1 and the path length differs by l/2 (i.e., a 180° phase reversal with respect to the direct path). For most practical purposes, only the first Fresnel zone need be considered. A radio path has first Fresnel zone clearanceif, as shown in Fig. objects capable of causing significant diffraction can not penetrate the corresponding ellipsoid. Network Services :Transmission Planning

  13. First Fresnel Radius, F1 = in mtr. where d1 and d2 are the distances ( in mtr) from the tip of the obstacle to the two ends of the radio link and f is frquency in GHz. REFLECTIONS : • Ground reflections:smooth ground or bodies of water. Ground reflections can be good news or bad news, but are more often the latter. In a radio path consisting of a direct path plus a ground-reflected path, the path loss depends on the relative amplitude and phase relationship of the signals propagated by the two paths. In extreme cases, where the ground reflected path has Fresnel clearance and suffers little loss from the reflection itself (or attenuation from trees, etc.), then its amplitude may approach that of the direct path. Then, depending on the relative phase shift of the two paths, we may have an enhancement of up to 6 dB over the direct path alone, or cancellation resulting in additional path loss of 20 dB or more. Network Services :Transmission Planning

  14. Effects of Rain, Snow and Fog The loss of LOS paths may sometimes be affected by weather conditions (other than the refraction effects which have already been mentioned). Rain and fog (clouds) become a significant source of attenuation only when we get well into the microwave region. Attenuation from fog only becomes noticeable (i.e., attenuation of the order of 1 dB or more) above about 30 GHz. Snow is in this category as well.Rain attenuation becomes significant for> 10 GHz, where a heavy rainfall may cause additional path loss. Network Services :Transmission Planning

  15. Microwave Link’s Parameters … • Free Space Loss FSL (db)= 92.45 + 20*LOG( fGHz*dKm ) • Propagation Loss The propagation loss relative to the free-space loss is the sum the following contributions: • attenuation due to atmospheric gases( Considearble for > 15 Ghz) • multipath fading • attenuation due to precipitation NORMAL RADIO PATH : In a normal Radio Path, Net Path Loss = FSL + Aa + Lf1 + Lf2 + Lb + Lo Where, Aa = attenuation due to atmospheric gases, Lf1 & Lf2 = feeder loss in dB Lb = branching loss in dB (circulators, filters) Lo = other loss in dB (e.g. attenuators , degradation of threshold) Network Services :Transmission Planning

  16. Signal strength received at Receiver is given by RSL(dBm) = Pt(dBm) – Net Path Loss(dB) + Gt(dBi) + Gr(dBi) Where Pt = Transmissted Power; Gt = Tx Ant Gain; Gr = Rx Ant Gain FADING MARGIN : The difference between normal received signal level and the receiver threshold level is called the fading margin: FM (dB) = RSL (dBm) – PTh(dBm) { - PThdeg } Network Services :Transmission Planning

  17. PARAMETERS Which Affect the Link Reliability… • FADING For small percentages of the time a path may experience that the signal level decreases or that the signal gets distorted. This signal fading is mainly due to two mechanisms calledmultipath fadingand fading due to precipitation (rain). Outages due to multipath are normally of short duration, less than 10 seconds. The sum of these outages gives the error performance of the radio relay system and should be compared with the ITU-R objectives given in ITU-R recommendations. Signature Information and Selective (Dispersive) Fade Margin is calculated using ITU P.530-6 and ITU-R P.530-7. A default value of 40 db is used only when no signature information has been defined in the radio equipment database. On the other hand,outages due to precipitation last longer than 10 consecutive secondsand are therefore termed unavailability and are added to the total unavailability of the radio-relay system. This total unavailability should be compared with the unavailability objectives given in ITU-R recommendations. Network Services :Transmission Planning

  18. UNAVAILABILITY DUE TO RAIN On any path there is a possibility of additional attenuation of the radio signal due to absorption and scattering by rain and sleet. This can be ignored at frequencies below 5 GHz. At higher frequencies, in particular above 10 GHz, it can be quite significant. The model described inITU-R Rec. P.530 [5.]is used to calculate the unavailability due to rain. The rainfall contour maps may be used if specific rainfall data for the region of interest is not available. Network Services :Transmission Planning

  19. Unavailability due to rain is given by : Where, Effective Path Length, d = actual path legth = Specific Rain Attenuation k and a are regression coefficients that have been calculated for oblate spheroid raindrops for a range of frequencies. These parameters are appropriate to the polarization. These regression coefficients are given in ITU-R Rec. 838 [2.]. It should be noted that the specific attenuation is lowest for the vertical polarization. R - the rain intensity in mm/h not exceeded for more than 0.01% of the worst month. Network Services :Transmission Planning

  20. Radio Threshold : It is the minimum RSL which a radio Receiver can receive with a specified BER ( Generally: 10e-6 as Low BER & 10e-3 as High BER). It is sometimes termed asRadio Sensitivity. Threshold Degradation : It describes how much the cumulative interference will decrease the radio’s sensitivity.It is based on the equation where interference is considered to cause extra internal noise for radio equipment. Network Services :Transmission Planning

  21. Unreliability Equations… Unreliability caused by Rain: It is given byPrain ( < 0.005 %) Unreliability caused by Equipment : Pe ( <0.0022831 % single - end) Total Annual Outage :PT = Pns + Ps + Pxp Where, Pns – outage due to flat fading Ps – outage due to selective fading Pxp – reduction of the cross polar discrimination Total Annual Unavailability :PURe = PT + PE + PR Total Annual Availability :PRe = 100 - PURe Network Services :Transmission Planning

  22. FRQUENCY PLANNING… • Connectivity Terminology • Chain • Star • Mixed • Ring / Loop Hi / Lo Concept Frequency selection / Polarization selection Done by Tool Network Services :Transmission Planning

  23. 64 kbps Channel 16 kbps Channel E1/PCM : 2048 kbps For a 4+4+4 BTS: Total TRX = 12 One TRX = 8 Ch. Of 16 Kbps each One TRX = 2 Ch. Of 64 kbps in E1 12 TRX = 24 Ch. in E1 TRXSIG (LAPD-Sig) : 16 Kbps for each TRX 12 TRX => 16*12/64 = 3 Ch. in E1 BCFSIG (OMU) : 16 Kbps Total Requirement : 24+3 = 27 Ch. of E1 plus 16 Kbps (2 bits) for OMU. Rest will carry no traffic. Network Services :Transmission Planning

  24. RADIO RELAY LINK… Branching Loss + Gt + Gr Branching Loss FSL Atmospheric Loss - Lt - Lr Pt Rx Tx/Rx Tx/Rx 34.4 Mbps/155.52 Mbps MUX MUX 16 E1s / 63 E1s Access / Backbone Network Services :Transmission Planning

  25. A Typical Radio relay System… Figure : Simplified block diagram of the transmitter (a) and receiver (b) of a wireless communication system. Network Services :Transmission Planning

  26. PDH MUX Network Services :Transmission Planning

  27. PDH Hierarchy Network Services :Transmission Planning

  28. SDH MUX Network Services :Transmission Planning

  29. SDH Hierarchy Network Services :Transmission Planning

  30. Atmosphere surrounding Earth Figure : Atmosphere surrounding Earth. Network Services :Transmission Planning

  31. Frequency Bands… Network Services :Transmission Planning

  32. THANK YOU... Network Services :Transmission Planning

More Related