1 / 13

T400 Motor Replacement

T400 Motor Replacement. Tools Require. Phillips screw driver 2mm, 8mm hex screw driver 17mm,19mm ,32mm wrench A djustable wrench. Remove blade. Remove arbor bolt (Figure 1) to remove blade. Figure 1: Arbor flange and bolt. Arbor Flange.

courtneywilliams
Download Presentation

T400 Motor Replacement

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. T400 Motor Replacement

  2. Tools Require • Phillips screw driver • 2mm, 8mm hex screw driver • 17mm,19mm ,32mm wrench • Adjustable wrench

  3. Remove blade Remove arbor bolt (Figure 1) to remove blade Figure 1: Arbor flange and bolt

  4. Arbor Flange • Remove inside flange from shroud by removing set screw at the bottom of the shroud. Figure 2: Arbor flange and set screw

  5. Remove shroud -Pull off inside flange and unscrew the four bolts on the shroud -Then disconnect the hoses from the top of the shroud Figure 3: Shroud Water line

  6. Remove Belt Loosen four bolts that hold motor to remove belt, then loosen the set screw and pull off the pulley (Figure 4) Figure 4: T400 belt Motor roller

  7. Motor Bolts -Remove 4 bolts that hold motor (front and back) -Remove motor wire connectors Figure 5: Motor bolts Power connector

  8. T400 Motor -Level motor mounting table and lock the feed handle -Pull out motor Figure 6: T400 motor

  9. Replace Roller and Belt • Set new motor in place • Install motor drive wheel and belt Figure 7: T400 drive wheel T400 belt

  10. Power connector Reconnect power cables according to diagram on back of the cover Replace cover and tighten screws Figure 8: Motor bolts Power connector

  11. Motor shroud Reconnect hoses on the top of the shroud Slide on the shroud and tighten the four screws Figure 9: Shroud Water line

  12. Aligning Inside Flange • Reinsert arbor flange. Then tighten the arbor blade and bolt before reinserting set screw inside flange Figure 10: Arbor flange Arbor blade

  13. Inside Flange Tighten the set screw that holds the inside flange Figure 11: Set screw hold the flange

More Related