1 / 19

EXP810 cabled to DS4700 and DS4800

EXP810 cabled to DS4700 and DS4800. Objectives. List the basic steps for installing the DS4700 or DS4800 with the EXP810 drive enclosures Employ proper cabling techniques/methodology Follow proper power on/off sequence. Steps for Hardware Install.

elan
Download Presentation

EXP810 cabled to DS4700 and DS4800

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. EXP810 cabled to DS4700 and DS4800

  2. Objectives • List the basic steps for installing the DS4700 or DS4800 with the EXP810 drive enclosures • Employ proper cabling techniques/methodology • Follow proper power on/off sequence

  3. Steps for Hardware Install • Unpack the hardware according to the directions in the unpacking guide that should be attached to the outside of the shipping carton. • Install the cabinet, controller enclosure and drive expansion enclosures by following the directions in the hardware installation guide. • Attach the power cables. • Attach Ethernet cables - one to each controller. • Cable the controller and drive expansion enclosures. • Check the link rate switch on all enclosures. • Turn on the power in the correct sequence. • Set the controllers’ IP addresses • Attach the host interface cables

  4. Cables

  5. Cabling

  6. Cabling B A A B Expansion Trays Controller Tray

  7. 1 Expansion Tray Expansion Tray Controller Tray

  8. 2 Expansion Trays Expansion Tray Expansion Tray Controller Tray

  9. 3 Expansion Trays Expansion Tray Expansion Tray Expansion Tray Controller Tray

  10. 4 Expansion Trays Expansion Tray Expansion Tray Expansion Tray Expansion Tray Controller Tray

  11. 5 Expansion Trays Expansion Tray Expansion Tray Top-Down Bottom-Up Expansion Tray Expansion Tray Expansion Tray Controller Tray

  12. 6 Expansion Trays Expansion Tray Expansion Tray Expansion Tray Top-Down Bottom-Up Expansion Tray Expansion Tray Expansion Tray Controller Tray

  13. Cabling

  14. DS4800 Cabling with EXP810

  15. Full Configuration with EXP810s Loop pairs 1 and 3 will run at the same speed Loop pairs 2 and 4 will run at the same speed

  16. DS4800 and EXP810 and EXP710 Intermix Guidelines – Per Loop Configurations where a total number of drives over 112 per loop are not supported.

  17. DS4700 / EXP810 - enclosure LED's Link Rate Switch: Left – 4Gbps Right – 2Gbps

  18. Turn on the Power • drive enclosures • controller enclsoure Turn off the Power • controller enclosure • drive enclosures

  19. Any Comments?

More Related