UK Cable Ties - How to Install Stainless Steel Cable Ties

1. How to Install Stainless Steel Cable Ties Stainless Steel Cable Ties are an excellent alternative for supporting extremely heavy loads. As shown below, they can withstand substantially higher loads than the nylon equivalent. Remember that the values displayed are per tie. You can hold considerably heavier weights if you start using many knots. Both sides of stainless ties are completely smooth. They lack the ridged surface on the bottom, making them more difficult to grip by hand. While it is feasible to tie these knots by hand, it will become tiring soon and you may not be able to make them as tight as you would like. UK Cable Ties is one of the most distinguished supplier of Coated stainless steel cable ties in UK. One approach is to pull the tail of the tie using a decent set of Pliers. This will help to tighten the tie more than pulling it by hand would. However, no two ties are likely to be tightened to the same degree. In addition, the tail of the tie must be removed. Using a Stainless Steel Cable Tie Gun is the best method. These gadgets will tighten the tie to a certain level and eliminate the tail, leaving no sharp edges. If you're going to be applying several cable ties, this is unquestionably the fastest and most comfortable approach to utilise. UK Cable Ties is a noted distributor of the best Stainless Steel Cable Ties in UK. Stainless Steel Cables Ties Installation: Stainless Steel Cable cable ties are speciality cable ties that must be properly put in order to work to their full potential. There are two options for installing Stainless steel Cable ties. 1. Installation without using Special Tools: Stainless steel Cable ties zip close with a rapid pull, and they may be opened by pressing the ratchet up with a flathead screwdriver. Some ties are made of metal powder, which allows the cables to be cut with conventional cutters; others are made of thin wire, which necessitates the use of metal-specific cutters.

2. UK Cable Ties is the leading exporter of Stainless Steel Cable Ties in UK. A ball bearing head is used in Stainless Steel Cable ties and some nylon coated ties. This permits the cable to enter freely into the head, but if pulled on, it will wedge itself against the cable. Any cable coming out of the head can be removed using tin snips, but a strap or cable cutter will provide a cleaner cut. 2. Installation using Special Tools: A cable tie installation tool is designed to tighten and cut the tie in the same operation. Power tools are commonly utilized in commercial settings, but manual tools are a viable option for home installation. After pushing the strap through the skull, it is fed into the tool until the tool's end is against the head. Squeezing the trigger forces the cable through the tool and tightens the Stainless Steel Cable tie. When the appropriate tension is obtained, the pull will drive a blade into the cable, cutting it to length.