English

1. English By Bjørnar, Øystein and Thomas • Installation of heating cables, a light and an outlet with a thermostat and two pole circuit breaker

2. The Fuse box • The fuse box wiring starts with three phases. • They pass trough the main fuse and the kW/h measurer. • There is no earth switch in this box since every circuit has its own fuse with a built in earth switch. • The fuses job is to protect the cable from getting fried during over charge and short circuit. • On the top we have the earthtrack

3. Wall box • These red boxes are used as a mount point for switches, thermostat, dimmers and timers. • If you look on the box on the right the one with the thermostat there is two yellow and green wires. There is a red cap on them it is called a Torex and it twists two or more wires togetter to create a good connection.

4. Heatingcables • These are heating cables. • They are installed under the floor. • After installation a mass of some substance is puton top before the floor is covered. • You need to be carful so you don’t break the cable.

5. We need Mario • In this picture we found an error. • The pipe is not properly attached to the box. • If this happened in real life then we are screwed, then we can not pull the wire through the pipe.

6. The Light • In these red boxes we can also attach light sockets. Usually we use the white boxes with a bit wider radius and a bit shorter width.

7. >>>>>>>>>>>>>>>>>>>>>>> • Fuse > Installation box mounting > piping >

8. That concludes our presentation