1 / 17

Easy Steps to Car Window Tinting.

If you need more information related to car window tinting then visit on our website.https://www.justlink.com.au/car-window-tinting

JustLink
Download Presentation

Easy Steps to Car Window Tinting.

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Easy Steps to Car Window Tinting

  2. Collect material that would be required for car window tinting before you start the process.

  3. Use the outside of your car window as a template and cut out sheets of the exact size.

  4. Side windows need to be sprayed with a mixture of water and soap.

  5. Any residue should be removed by using a razor.

  6. A 4-inch squeegee could be used to get rid of residue. The residue needs to be pasted out of the film.

  7. Then the tint needs to be applied on the window. Ensure that you leave about 1/4 to 1/16 inch from the edge (top edge) as that part would get covered when the windows are rolled up and the door are closed.

  8. The tint then needs to be pressed into the inner rubber seal of the car window.

  9. A card can be used so that the film goes even to each and every corner.

  10. To ensure that the film is cleanly stuck, you should use a hand drier over the window. Make sure that you blow dry till the time there is no moisture content between the tint film and the glass.

  11. Then go for tinting the front car window in the same fashion.

  12. There after the back car window needs to be done, without skipping a single step.

  13. Then the number of defroster heater lines need to be counted on the back window.

  14. The rear window film sheet needs to be cut into the required panels.

  15. Place the panels one over the other. Where the two panels over lap identify the heater lines.

  16. Trim in case of defroster lines.

  17. If you have any requirement or need any other information then please car window tinting then please visit on our website. https://www.justlink.com.au/car-window-tinting

More Related