Heat Recovery Products By Uni Klinger

1. FLUID CONTROL DIVISION WWW.UNIKLINGER.COM Visit @ Heat Recovery Products

2. HEAT RECOVERY PRODUCTS Steam Injectors Power Pump Unit Deaerator Head Flash Vessels It draws in cool liquid from one end and mixes it with the steam being injected. These ensure full utilization of the total heat as well as avoid Flashing and noise. It used to pump condensate to the desired location and are cheaper to operate against electrically operated pumps which require special impellers to avoid risk of cavitations by condensate and temperature limits of condensate to be handled. The steam can be separated from the condensate in the flash vessels through which steam can be collected and distributed to processes requiring low pressure steam, can return back to mix with feed water, can utilize for generation of hot water De-Aerator is a dome shaped device [called the mixing unit] fitted to the Feed Water Tank, having three Nozzles for Cold Make up Water, Recovered and recycled hot condensate and Flash Steam. Visit @ Heat Recovery Products

3. DEAERATOR HEAD Available in 4 sizes having different capacities. Others on request. Features: Removes Air, Oxygen, and other non condensable gases. Provides effective mixing of BFW with available thermal streams. Immersed Perforated Pipe allows uniform heating in Feed water tank. Improves efficiency of Boilers by preheating Feed water. SS internals avoid corrosion. HP boilers can afford to go for a pressurized de-aeration system, But for process boilers a separate DA vessel will cost as much as the boiler cost and may not be affordable and justified. Visit @ Heat Recovery Products

4. STEAM INJECTORS UKL Steam Injector in Austenitic Stainless Steel construction. Steam Injectors are used for heating Water, Feed water, Process media, process liquors etc by direct injection of steam into the media. Available in MOC SS316 Sizes: 15 to 50mm others on request Ends Connection: BW/ Threaded to BSP/BSPT/NPT Max Pressure: PN25 Max Temperature: Saturated Max recommended Heating temperature:90 Deg C Visit @ Heat Recovery Products

5. PRESSURED POWER PUMP UNIT UKL condensate recovery system can be used with motive as Steam or Compressed Air. Available in Carbon Steel Insulation can be provided as optional. Features: Pump is supplied as a complete skid mounted unit, inclusive of the condensate receiver, the main pumping unit, and other necessary accessories. Uses on 3 kg of steam for every 1000 liters of condensate pumped. Visit @ Heat Recovery Products

6. FLASH VESSELS Available in Five different dimensions, as a complete assembly with Safety valves, pressure gauges, Trap assembly etc. Or, stand alone Flash vessel. Insulation jacket can be provided on request. Flanged to ANSI #150. IBR on request. Material of Construction Carbon Steel. Maximum Working pressure 10.5Kg/cm2 at 180Deg C. Visit @ Heat Recovery Products

7. FLASH VESSELS Features: UKL Flash vessel is an excellent tool for energy conservation. Under different operating parameters UKL Flash Vessel pays back for its cost in less than approximately 45 days. High pressure condensate will release as much as 10-15 % of LP steam that can be put back into process loop for substantial monetary gains. The UKL Flash Vessel is generously sized to ensure low flow velocities that help easy separation of released steam from the condensate. A safety valve provided on the flash vessel will ensure safety of the equipment where this LP steam is proposed to be used. A check valve if fitted at outlet of flash steam ensure preventing any back pressure that may cause in the event HP condensate is not generated in the process. A Float trap is connected at Condensate outlet to restrict the flash steam flow with condensate. Visit @ Heat Recovery Products

8. VISIT +91 20410 23000 www.uniklinger.com Kohinoor Estate, SC 1, 5th Floor Opp. Bajaj Garden, Pune - Mumbai Road Khadki, Pune - 411003 Visit @ Heat Recovery Products