1 / 11

Overview of ProE Part #SE141-013 And Notes Indicating Revised Geometry

Overview of ProE Part #SE141-013 And Notes Indicating Revised Geometry. D. Williamson, 7/1/03. The first feature is a wireframe offset of the winding surface. The wireframe was created by offset and smoothing to remove “fold-over” problems in the inboard region.

abril
Download Presentation

Overview of ProE Part #SE141-013 And Notes Indicating Revised Geometry

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Overview of ProE Part #SE141-013 And Notes Indicating Revised Geometry D. Williamson, 7/1/03

  2. The first feature is a wireframe offset of the winding surface. The wireframe was created by offset and smoothing to remove “fold-over” problems in the inboard region. Link to winding surface geometry (ibl,igs).

  3. A surface and thin protrusion are created using the wireframe curves. Several copies of the surface are also made for later use. A preferred method for this feature is a “blend-from-file” that has curves every two deg in the toroidal direction. The surface can then be updated by replacing the referenced .ibl file. See ws_off55.ibl as an example.

  4. Next features are flanges and tee. The tee is copied from se141-013_tee.prt, and is made as a variable section sweep using two trajectory curves. The trajectory curves have been revised. The new curves are called wc3_e04 (ibl,igs) and xv3_e04 (ibl,igs).

  5. The wings are added by trimming the copied surfaces. A preferred method would be to make the “blend-from-file” surface large enough to include the wings. The surface would need to move in/out to accommodate the wings of the adjacent coils. See next slide as an example.

  6. Proposed inner surface for winding form Type-C Link to inner_surf.igs Surface offset 2-in to accommodate adjacent coil Plan View Iso View

  7. Clamp slots are created using a patterned local coordinate system that is normal to winding law (wc-curve).

  8. Modular coil to TF coil interface Dimensions are:

  9. Poloidal break

  10. Flange holes Total features: 530 Datum Plane/Axis/Point, 46 Csys, 89 Curves/Surfaces, 16 Protrusions, 129 Cuts/Holes, 8 Copy_geom, 93 Other (Group, Analysis, etc)

  11. Component Build Dimensions 5.10 2.00 Nominal 1.00 Clamp 4.671 2.336 Winding 0.375 Dimensions in inches Not to scale 3/4 3/8 4.100

More Related