1 / 16

PLASMA FORMATION DURING OPERATION OF A DIODE PUMPED ALKALI LASER*

PLASMA FORMATION DURING OPERATION OF A DIODE PUMPED ALKALI LASER*. Aram H. Markosyan and Mark J. Kushner University of Michigan , Dept. Electrical Engineering and Computer Science, Ann Arbor, MI USA armarkos@umich.edu, mjkush@umich.edu International Symposium on Plasma Chemistry

afram
Download Presentation

PLASMA FORMATION DURING OPERATION OF A DIODE PUMPED ALKALI LASER*

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. PLASMA FORMATION DURING OPERATION OF A DIODE PUMPED ALKALI LASER* Aram H. Markosyan and Mark J. Kushner University of Michigan, Dept. Electrical Engineering and Computer Science, Ann Arbor, MI USA armarkos@umich.edu, mjkush@umich.edu International Symposium on Plasma Chemistry June 2015 * Work supported by Department of Defense High Energy Laser Multidisciplinary Research Initiative.

  2. University of Michigan Institute for Plasma Science & Engr. DIODE PUMPED ALKALI LASERS (DPAL) • DPAL is a class of optically pumped lasers that leverage inexpensive semiconductor diode lasers to pump alkali vapor. • Poor optical quality, wide bandwidth of diode laser (DL) is converted into high optical quality, narrow bandwidth from alkali laser. • DL pumps the D2(2S1/2 2P3/2) • Collisional quenching: 2P3/2 2P1/2 • Lasing on D1(2P1/2 2S1/2) • Requires inversion of ground state. • W. F. Krupke, Prog. Quant. Elect. 36, 4, (2012). ISPC2015

  3. University of Michigan Institute for Plasma Science & Engr. PLASMAS THROUGH RESONANT EXCITATION OF ALKALI VAPOR • LIBORS (Laser Ionization Based on Resonance Saturation), first proposed by Measures (1970), is an efficient means for producing plasmas in alkali vapor with low laser intensity. • Electron heating by super-elastic relaxation of laser produced M* rapidly avalanches to nearly full ionization. • Associative ionization (M* + M*  M2+ + e) by resonant states in Na, Li, K is exothermic – in Cs, AI is endothermic, and so requires states higher than Cs(62P1/2, 62P3/2). • R. Measures, J. Quant. Spec. Rad. Transf. 10, 107 (1970). ISPC2015

  4. University of Michigan Institute for Plasma Science & Engr. PLASMA FORMATION IN DPAL • In DPAL large densities of resonant excited states in alkali vapor are produced by laser pumping. • With pre-existing or laser generated seed electrons, super-elastic electron heating and associative ionization may result in plasma formation through aLIBORS-like process. • The resulting plasma has the potential to reduce or quench laser oscillation through electron collision mixing. • We discuss results from a computational investigation of the pulsed DPAL system in He/Cs/C2H6 and He/Cs/N2mixtures with lasing occurring on the Cs(62P1/2) → Cs(62S1/2) (894 nm) D1 transition. • The investigation focuses on the formation of plasma and its consequences on laser action. ISPC2015

  5. University of Michigan Institute for Plasma Science & Engr. DESCRIPTION OF MODEL • A global kinetics model, Global_KIN was used to assess plasma formation during DPALs. • Reaction mechanism developed for the He/Cs/C2H6and He/Cs/N2systems. • Te from rate and transport coefficients produced by local solutions of Boltzmann’s equation for the electron energy distribution (EED). • Cs/Cs2 densities determined by vapor pressure of cell (350 K – 425 K) • 5 cm long cell, 98% output mirror reflectivity. • No parasitic losses. • End-pumped by 1 µs DL pulses (PRF of many kHz) ISPC2015

  6. University of Michigan Institute for Plasma Science & Engr. Cs ELECTRON IMPACT X-SECTIONS • Database for electron impact processes in Cs is surprisingly sparse. • Ab initio calculations of e + Cs collisions were performed using two R-matrix (close-coupling) models . • Semi- relativistic using between 5 and 40 states (including pseudo-states for ionization) • Fully relativistic all-electron B-spline R-matrix with pseudo-states (DBSR) ansatz with 311 coupled states • For low-energy elastic scattering below the first excitation threshold a special polarized pseudo-state model was developed in order to reproduce the static dipole polarizability of the Cs ground state. • Full cross section sets developed for Cs(62S1/2, 62P1/2, 62P3/2, 52D3/2, 52D5/2, 72S1/2, 72P1/2, 72P3/2, Rydberg) • O. Zatsarinny, K. Bartschat, N. Yu. Babaeva and M. J. Kushner, Plasma Sources Sci. Technol. 23, 035011 (2014). • O. Zatsarinny, GEC 2014, Poster MW1.05 ISPC2015

  7. University of Michigan Institute for Plasma Science & Engr. EXAMPLE:E-IMPACT X-SECTIONS Cs(62S1/2, 62P3/2) • Cross sections for excitation exceed 20 2 at a few eV. • Multi-step excitation and superelastic relaxation have cross sections approaching 1002 at a few eV. • These large cross sections facilitate rapid conversion of laser power into hot electrons, and excitation of higher lying states. ISPC2015

  8. DPAL PUMPING: 852 nm, 1 kHz, tpump = 1 µs • [e] increases over 10s pulses to 1011 cm-3due to electron impact following superelastic heating and associative ionization. • Associate ionization of Cs(62P3/2) is endothermic – electron impact populates higher states which do associatively ionize. • During pump, lasing saturates laser levels in ratio of degeneracies. • Tcell = 375 K, 600 Torr, He/C2H6/Cs = 83/17/1.1x10-6 [Pvapor(Cs)=0.67 mTorr] • Pump: 852 nm, 1 kHz, tpump=1 s, 10 kW/cm2. ISPC2015

  9. University of Michigan Institute for Plasma Science & Engr. ELECTRON, GAS TEMPERATURES • During interpulse period Teis maintained by superelastic relaxation. • Quenching of laser levels and vibrational levels of C2H6and N2 produce incremental increases in Tgaseach pulse. • The rate of electron energy loss to C2H6(v) greatly exceeds that of N2(v). • Electron heating in DPAL with N2 significantly stronger than with C2H6. • In C2H6 power is removed by lasing, while in N2 it goes into electron heating. ISPC2015

  10. University of Michigan Institute for Plasma Science & Engr. LASER POWER • Higher threshold pumping at higher reservoir temperature and higher Cs vapor – larger density of ground state to invert. • At low pump power or high vapor density, laser is limited by pump rate – positive slope efficiency. • At high pump power or low vapor density, laser is limited by absolute Cs density to absorb pump power – laser saturates. • Oscillation at 894 nm. • 600 Torr, He/C2H6(N2)/Cs = 83/17 • Pump: 852 nm, 1 kHz, tpump=1 s ISPC2015

  11. University of Michigan Institute for Plasma Science & Engr. LASING EFFICIENCY • Due to saturation of laser intensity at high pumps (or low vapor density) efficiency decreases. • Higher laser power (and efficiency) is "bootstrapped" by raising temperature (vapor density) with pump rate. • Other limits at high pump areassociative ionization, photo-ionization and electron quenching which limits laser intensity. • In case of N2 significant amount of power goes into electron and gas heating. • Oscillation at 894 nm. • 600 Torr, He/C2H6(N2)/Cs = 83/17 • Pump: 852 nm, 1 kHz, tpump=1 s ISPC2015

  12. University of Michigan Institute for Plasma Science & Engr. ELECTRON DENSITY • As laser radiates, pump power (and excited state density) is removed from cavity more effectively for C2H6 than for N2. • Result is much higher electron and higher excited states density for N2than C2H6. • At low pump rate, inability to populate states higher than Cs(62P3/2) reduces ionization rates. ISPC2015

  13. University of Michigan Institute for Plasma Science & Engr. PUMP REPETITION FREQUENCY • At higher pump frequencies electron density builds up quickly. • Due to shorter interpulse periods, more energy remains in the system which goes into electron and gas heating. • As a result, output power drops sharply. ISPC2015

  14. University of Michigan Institute for Plasma Science & Engr. MOLE FRACTION OF RELAXANT • Larger mole fraction of collisional relaxant provides larger reservoir for energy storage in vib states. • As a result higher plasma density and worse lasing action. • Low mole fraction suffers due to insufficient collisional relaxation of Cs(62P3/2) to Cs(62P1/2). • At the Te of interest, C2H6 and N2 differ only in momentum transfer and vibrational/rotational excitation. • The rate of electron energy loss to C2H6(v) greatly exceeds that of N2(v). ISPC2015

  15. University of Michigan Institute for Plasma Science & Engr. PUMP-PULSE LENGTH • Pump energy per pulse is constant 10 kW/cm2 1μs at 1 kHz. • With shorter pulse duration, the absolute pump intensity increases. • Ionization and quenching processes scale as P2 (either multistep or collisions between excited states). • At higher pump power, more increase in quenching relative to pumping, and so less efficient. • By increasing pulse length, quenching decreases relative to pumping - laser efficiency increases.. • Further increase of pulse length stops lasing due to insufficient pump power. ISPC2015

  16. University of Michigan Institute for Plasma Science & Engr. CONCLUDING REMARKS • Results were discussed from a computational investigation of the pulsed DPAL system in He/Cs/C2H6and He/Cs/N2 mixtures with lasing on the Cs(62P1/2→ 62S1/2) (894 nm) transition. • Plasma formation is to some degree unavoidable when populating resonant states of alkali atoms(i.e., LIBORS) given seed electrons. • Cs lacks associative ionization of the Cs(62P3/2,1/2) which naturally provides seed electrons. However, if seed electrons exist, plasma should form. • In high repetition rate operation for high pump intensities, plasma densities > 1011 cm-3 - 1012 cm-3 are produced which produces a small decrease in laser intensity by electron collisions mixing. • The final plasma density depends on the operational space – pump pulse intensity, repetition rateand rate of energy loss to collisional relaxant. ISPC2015

More Related