1 / 6

ProJet 3000/3500 Training

Daily Agenda. ProJet 3000/3500 Training. Day 1. 8:30 AM: Meet at 3D Systems 8:30- 9:00: Welcome and Introduction 9:00- 9:15: Tour 3D Systems 9:15-10:00: Safety and Material Hazard 10:00-10:30: Removing and Replacing Side Panels 10:30-10:45: Break

agostino
Download Presentation

ProJet 3000/3500 Training

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Daily Agenda ProJet 3000/3500 Training

  2. Day 1 8:30 AM: Meet at 3D Systems 8:30- 9:00: Welcome and Introduction 9:00- 9:15: Tour 3D Systems 9:15-10:00: Safety and Material Hazard 10:00-10:30: Removing and Replacing Side Panels 10:30-10:45: Break 10:45-11:15: General Introduction of main assemblies 11:15- 12:00: Drop Mass Tests and Tag Tests 12:00- 1:00: Lunch 1:00- 2:30: X Motion System 2:30- 3:30: Printhead Introduction 3:30- 4:30: Planerizer Introduction 4:30- 5:00: Client Software 5:00: Dismissal 2 4

  3. Day 2 8:30 AM: Meet at 3D Systems 8:30- 10:30: Begin Installation Process 10:30-10:45: Break 10:45-12:00: Installation Process 12:00- 1:00: Lunch 1:00- 4:30: Installation Process 4:30- 5:00: Question and Answer 5:00: Dismissal 3 4

  4. Day 3 8:30 AM: Meet at 3D Systems 8:30- 10:30: Installation Process 10:30-10:45: Break 10:45-12:00: Planerizer wiper replacement 12:00- 1:00: Lunch 1:00- 3:00: UV Bulb replacement 3:00- 5:00: Material Feed System Removal and Replacement 5:00: Dismissal 4 4

  5. Day 4 8:30 AM: Meet at 3D Systems 8:30- 10:30: Printhead Recovery Procedures 10:30-10:45: Break 10:45-12:00: Z Motion, X Motion and Waste System 12:00- 1:00: Lunch 1:00- 5:00: RMT DIAGS 5:00: Dismissal 5 4

  6. Day 5 8:30 AM: Meet at 3D Systems 8:30- 9:00: Grade and Review Tests 9:00-10:30: Troubleshooting Test 10:30-10:45: Break 10:45-1:00: Error logs and troubleshooting tips 1:00: Dismissal or Remedial Classroom time 6 4

More Related