E N D
1. Anaesthetic circuits Samantha Morgan
3. Objectives By the end of the session students should be able to;
Describe Endotracheal intubation
List advantages and disadvantages of Endotracheal intubation
Recognise the common anaesthetic circuits
Calculate the fresh flow rate of patients on the different circuits
Perform a safety test on an anaesthetic machine
4. Endotracheal intubation Ensuring a patent airway
Ideally the tube should extend from the incisor to a point level with the spine of the scapula.
Surplus dead space is minimised by cutting off the projecting tube.
Choose the maximum tube diameter appropriate to the patient to minimise resistance to air flow
5. Intubation The jaws must be relaxed and laryngeal reflexes suppressed before intubation is attempted.
Laryngeal reflexes in cats persist to relatively ‘deep’ level of anaesthesia, and laryngospasm is not uncommon.
Lignocaine is used to depress this spasm.
6. Advantages of Endotracheal intubation Airway protection
Allows positive pressure ventilation
Reduces waste-gas pollution
Reduces anatomical dead space.
7. Disadvantages of Endotracheal intubation Airway resistance
Kinking or occlusion possible
Traumatic laryngitis
Chemical/ischemic tracheitis
Apparatus dead space
Endobronchial intubation
Surgical interference from the tube.
8. Endotracheal tubes Magill tube
3 mm to 40 mm internal diameter
plain or with an inflatable cuff
Can also be made from PVC (Portex)
9. Endotracheal tubes Endobronchial intubation
Inserted into one of the main stem bronchi
arterial hypoxemia
cyanosis
laboured breathing
uptake of the inhalation anaesthetic agent may be impaired
10. Endotracheal tubes Impaction
Tip of the tube against the tracheal wall
The Murphy eye
11. Endotracheal tubes Herniation of the cuff
Compression of the lumen
12. Endotracheal tubes Stretching of the tracheal wall
Tracheitis
Pressure necrosis of the tracheal wall
Tracheal rupture.
13. Endotracheal tube check Correct size
Check patency
Check cleanliness
Check cuff and balloon are functioning
Ensure adequate lubrication to avoid mucosal trauma.
14. Laryngeal Masks 1980s
Alternative to endotracheal intubation
Difficulties in producing a gas-tight seal in animal patients
Considerable cost
15. Mask inductions-advantages Do not damage the airway
Produce smooth induction when patients are depressed or heavily sedated.
16. Mask inductions-disadvantages Causes resistance/anxiety to poorly sedated patients
Mask increases mechanical dead space
Limited ventilator support during IPPV
Greater atmospheric pollution.
17. Circuits Used to deliver anaesthetic agents
Can be classified as rebreathing and non-rebreathing
Ventilation
Inspiration
Expiration
End expiratory pause
18. Calculations Tidal volume
10-15mls x Bodyweight (kgs)
Respiratory minute volume
Tidal volume x respiratory rate (BPM)
19. How do we end up with circuit factors?....
By calculating the resistance of the circuit
Tube diameter alters the resistance
Corrugated tubing has a greater pull
Flushing the system
20. Reservoir bags The volume should be 3-6 times the patients tidal volume.
Oversized bags increase circuit volume
Inadequately sized bags collapse during large breaths and over distended during expiration.
For small animal use, 2,4 and 6 litre bags are required.
21. Circuits
22. Ideal breathing system Simple, safe and inexpensive
Delivers intended inspired gas mixture
Permits spontaneous, manual and controlled ventilation in all age groups
Efficient, allows low fresh gas flow
Protects patient from barotrauma
Sturdy, compact, lightweight
Permits easy removal of gases
23. Rebreathing circuits
Exhaled gases are collected and the exhaled CO2 is removed
Sodalime
Flow rate is approximately 5-10mls/kg/min
24. Advantage of re-breathing circuits
Low flow rate
Cheaper to run
Lower theatre contamination
Less anaesthetic agent requirements.
25. Disadvantages of re-breathing circuits Respiratory tract irritation
Heavy
Need to check soda lime
Heat produced
Higher resistance.
26. De-nitrogenation Patients expire considerable volumes of nitrogen
Lowers circuit oxygen levels
Use high flow rates for the first 10-15 mins of anaesthesia
or
Empty the reservoir bag every 3 minutes for the first 15 minutes.
27. To and Fro Bidirectional flow improves CO2 scrubbing efficiency
Greater heat conservation
Lower low circuit volume
Can roll off table
Suitable for patient over 7kgs
Valve position is inconvenient for IPPV
28. Circle circuit High gas efficiency
Less circuit inertia unlike to and fro
Can be expensive and cumber some
For animals over 5-10kgs
Unidirectional flow is dependant on the valves.
29. Soda lime Baralyme
Soda lime
94% calcium hydroxide
5% calcium hydroxide
1% potassium hydroxide
Water
pH sensitive dye
30. Soda lime Two types
White to purple
Pink to white
Exhausted after about 8 hours
Colour change will disappear!
31. Non-rebreathing circuits
Rely on adequate gas flow rate
remove carbon dioxide from the circuit
avoid re-breathing of expired gas.
32. Ayres T’piece Jackson-Rees modification
Circuit factor 2.5-3 x minute volume
33. Ayres T Piece Minimal apparatus, dead space and resistance
Simple and inexpensive
Good for IPPV
Fresh gas flow (FGF) is high
Need the modified system to scavenge effectively
Afferent reservoir system
34. Magill Circuit factor 1-1.5 x minute volume
35. Magill For use in dogs greater than 8kgs
If no end expiratory pause you can get mixing of gases
Cumbersome at patient end as scavenging attaches there
Inexpensive
Efferent reservoir system
36. Bain Circuit factor 2.5-3 x minute volume
Useful circuit for IPPV
Basically same as Ayres
Watch frequently the inner tube becomes disconnected, kinked and leaks!
Afferent reservoir system
37. Lack Circuit factor 1-1.5 x minute volume
38. Lack For dogs over 10kgs
Similar to Magill but with the valve more conveniently placed
Should not be used for prolonged IPPV
Afferent reservoir system
39. Mini Lack Smaller version of standard
Alternative to Ayres
Bodyweight range 1-10kg
Circuit factor 1-1.5 x minute volume
40. Humphrey ADE Has three different modes
Semi-closed system for under 7-10kg
Recycling for over 7-10kgs
Ability to connect a ventilator
42. Anaesthetic machine check Open the oxygen cylinder valve
Slowly anticlockwise
43. Anaesthetic machine check Check the registered quantity of oxygen on the pressure dial
44. Anaesthetic machine check Turn on the oxygen flow meter control to check smooth function
Turn it off after this
45. Anaesthetic machine check Press the emergency oxygen flush button
46. Anaesthetic machine check Attach the “in use” label to oxygen cylinder
47. Anaesthetic machine check Check the vaporiser percentage dial to ensure it turns easily
48. Anaesthetic machine check Check the level of the volatile agent in the vaporiser