1 / 22

Making a Rail Car by Stan Pope and Victor and Rob

Making a Rail Car by Stan Pope and Victor and Rob. Working axles - a groove to hold the nail. Working axles - nail in the groove. Working axles - ready to file the bumps off . Working axles - holding the file steady. Working axles - Guiding file with right hand.

albert
Download Presentation

Making a Rail Car by Stan Pope and Victor and Rob

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Making a Rail Carby Stan Popeand Victor and Rob

  2. Working axles - a groove to hold the nail

  3. Working axles - nail in the groove

  4. Working axles - ready to file the bumps off

  5. Working axles -holding the file steady

  6. Working axles - Guiding file with right hand

  7. Polish with jeweler's rouge on a rag.

  8. Draw the side views

  9. Draw the top view

  10. Line the drill up with the axle line and drill carefully

  11. At this point, cut the car off the block. Use whatever means are available ... table saw, hand saw, planer, etc.

  12. Make a place for the saw blade to work inside the car

  13. Cut out the end

  14. Detach one end of the blade ...

  15. Put the car around the blade ...

  16. Fasten the blade and you're “good to go.”

  17. A coping saw will do this job, too

  18. Weigh all the pieces, allow for epoxy.

  19. Pound weights into shape to fitTape over the axle holes

  20. Set weights so that they are ready to go in the right place.

  21. Add Epoxy and fold the waxed paper over. Press to shape.

More Related