250 likes | 540 Views
Earthquakes. Done by: Sun Yudong (1o2 27) Teo Jun Wei (1o2 30). What is an earthquake?. a shaking of the ground caused by the sudden breaking and movement of large sections (tectonic plates) of the earth's rocky outermost crust Earthquakes shake at different intensities
E N D
Earthquakes Done by: Sun Yudong (1o2 27) Teo Jun Wei (1o2 30)
What is an earthquake? • a shaking of the ground caused by the sudden breaking and movement of large sections (tectonic plates) of the earth's rocky outermost crust • Earthquakes shake at different intensities • They can be measured and presented as data using the Richter scale.
Shaking intensity of an earthquake • Measured on Shaking intensity scales • developed to standardize the measurements and ease comparison of different earthquakes. • Shaking intensity varied from barely perceptible to completely destructive. • The lower numbers represent imperceptible shaking levels, XII represents total destruction. • Below is the table to measure the shaking intensity:
Devices to measure the earthquake • Earthquakes are measured using seismometers. The moment magnitude is the most common scale on which earthquakes larger than approximately 5 are reported for the entire globe. • These earthquakes are measured as some number on the Rictherscale.
Earthquake fault types • Three main types of fault that may cause an earthquake: • Normal • reverse (thrust) • strike-slip as shown on the right
Earthquake fault types • Normal and reverse faulting are examples of dip-slip, • the displacement along the fault is in the direction of dip • movement on them involves a vertical component. • Normal faults occur mainly in areas where the crust is being extended such as a divergent boundary. • Strike-slip faults are steep structures where the two sides of the fault slip horizontally past each other.
Why do earthquakes happen away from plate boundaries? • Plate boundaries an obvious place for earthquakes to occur. • However, the stresses at plate boundaries can manifest themselves some distance away from the surface evidence of the boundary. • Equally, boundaries have fault lines which radiate from them and are common causes of earthquakes.
Countries that commonly experience earthquakes • Japan • China • Chile • Australia continent • Countries around the Ring of fire • Alaska • Philippines • Indonesia • Haiti
What is an aftershock? • Is an earthquake that occurs after a previous earthquake, the mainshock. • Is in the same region of the main shock but always of a smaller magnitude. • If an aftershock is larger than the main shock, the aftershock is redesignated as the main shock and the original main shock is redesignatedas a foreshock. • Aftershocks are formed as the crust around the displaced fault plane adjusts to the effects of the main shock
The possible effects of earthquakes • Shaking and ground rupture • Landslides and avalanches • Soil liquefaction • Tsunami
The possible effects of earthquakes • An earthquake may cause • injury and loss of life • road and bridge damage • general property damage • collapse or destabilization of buildings • potentially leading to future collapse
The possible effects of earthquakes • The aftermath may bring • Disease • lack of basic necessities • higher insurance premiums • Earthquakes can also cause • volcanic eruptions, bringing further problems.
Shaking and ground rupture • Ground rupture is a visible breaking and displacement of the Earth's surface along the trace of the fault • may be of the order of several metres in the case of major earthquakes. • Ground rupture is a major risk for large engineering structures such as dams, bridges and nuclear power stations • requires careful mapping of existing faults to identify any likely to break the ground surface within the life of the structure.
Shaking and ground rupture • Shaking and ground rupture are the main effects created by earthquakes, • principally resulting in more or less severe damage to buildings and other rigid structures. • The severity of the local effects depends on the complex combination of the • earthquake’s magnitude • the distance from the epicenter • and the local geological and geomorphological conditions, which may amplify or reduce wave propagation. • The ground-shaking is measured by ground acceleration.
Shaking and ground rupture • Specific local geological, geomorphological, and geostructural features can induce high levels of shaking on the ground surface even from low-intensity earthquakes. • This effect is called site or local amplification. • It is principally due to the transfer of the seismic motion from hard deep soils to soft superficial soils and • to effects of seismic energy focalization owing to typical geometrical setting of the deposits.
Landslides and avalanches Landslides and avalanches
Landslides and avalanches • can produce slope instability leading to landslides or avalanches • Landslide is a major geological hazard • Landslide danger may persist while emergency personnel are attempting rescue. Landslides and avalanches
Soil liquefaction • Soil liquefaction occurs when, because of the shaking, water-saturated granular material (such as sand) temporarily loses its strength and transforms from a solid to a liquefied solid. • Soil liquefaction may cause rigid structures, like buildings and bridges, to tilt or sink into the liquefied deposits. • This can be a devastating effect of earthquakes. • For example, in the 1964 Alaska earthquake, soil liquefaction caused many buildings to sink into the ground, eventually collapsing upon themselves.
Tsunamis • Tsunamis are long-wavelength, long-period sea waves produced by the sudden or abrupt movement of large volumes of water. • In the open ocean • the distance between wave crests can surpass 100 kilometers (62 miles) • the wave periods can vary from five minutes to one hour.
Tsunamis • Such tsunamis travel 600-800 kilometers per hour (373–497 miles per hour), depending on water depth. • Large waves produced by an earthquake or a submarine landslide can overrun nearby coastal areas in a matter of minutes. • Tsunamis can also travel thousands of kilometers across open ocean and wreak destruction on far shores hours after the earthquake that generated them.
Tsunamis • Ordinarily, subduction earthquakes under magnitude 7.5 on the Richter scale do not cause tsunamis, although some instances of this have been recorded. • Most destructive tsunamis are caused by earthquakes of magnitude 7.5 or more.
References Special thanks to: • http://eqseis.geosc.psu.edu/~cammon/HTML/Classes/IntroQuakes/Notes/intensity.html • http://en.wikipedia.org/wiki/Earthquake • http://earthquake.usgs.gov/