How To Accurately Install And Adjust Champion Pressure Switches

1. How To Accurately Install And Adjust Champion Pressure Switches? | Emergency Sales and Service The start and stop of a well water pump is typically controlled by champion pressure switches. The switch is preset with both the cut-on as well as cut-off pressure. The Cut-on pressure is the low pressure that initiates the pump and the cut-off pressure is the high pressure that turns off the pump. Are you in search of premium quality champion pressure switches? Emergency Sales and Service is the optimum online destination that you should consider for buying pressure switches at an affordable price. In this post, we will learn about how to install and adjust champion pressure switches. Let’s get started… How To Install And Adjust Air Pressure Switches? 1.Before you remove cover ensure that switch is in the OFF position 2.Install ½” x 2” nipple and ½” pipe plugs are needed 3.Unloader valve position can be rotated by loosening the 3 mm Alken head screw, reposition then tighten 4.Using two wrenches tighten the unloader compression fitting 5.Allow wire incoming power to Line Terminals 6.Wire motor leads to Motor Terminals 7.Be sure to ground screws safely 8.Turn pressure adjustment screw clockwise to increase pressure

2. 9.Turn pressure adjustment screw counter clockwise to decrease pressure 10.Before replacing cover be sure to turn switch to OFF position This will properly align the slot in the switch with the white transfer pin but do not over tighten cover screw. This was all about installing and adjusting pressure switches, now if you want to buy OEM champion pressure switches at an affordable price, then visit us now! Get-in-touch with us:- Contact Details:- Emergency Sales & Service, LLC 1551 Dorie Court,Fenton, MO. 63026 Tel- 636-496-7991 E-mail- sales@allaircompressorparts.com Website-http://www.allaircompressorparts.com/