1 / 15

APD and Electronics Testing

APD and Electronics Testing. Leon Mualem Univ. of Minnesota October 2, 2003. From Concept…. To Reality. Test Cooling Circuitry, Components, and Capacity. Actual board, powered and cooled to –25C. Fix Some Issues on Rev. A. Bypassing on V ref and V cc. Higher Value Resistors.

beau-moore
Download Presentation

APD and Electronics Testing

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. APD and Electronics Testing Leon Mualem Univ. of Minnesota October 2, 2003

  2. From Concept…

  3. To Reality

  4. Test Cooling Circuitry, Components, and Capacity

  5. Actual board, powered and cooled to –25C

  6. Fix Some Issues on Rev. A Bypassing on Vref and Vcc Higher Value Resistors Filter on voltage Regulator

  7. Initial Noise msmt at FNAL with new board • MASDA noise best case expected 330 e- • 15 Channels with reduced noise after fixes. • 4 @ 390e- • 6 @ 420e- • 3 @ 450e- • 2 @ 480e- • Reminder: This is an interim solution, a properly matched front end should get ~250e- according to Tom Zimmerman 18 Meg Ohms 9 Meg Ohms

  8. Noise testing parameters • Maximum bandwidth setting • 21mV/fC gain  300e-/mV • 1mV=1ADC count • Integration Time (SAFT-SBEF) = 2s

  9. Noise Levels on Bare Board W/10pF W/18M W/9M

  10. Fit to noise showing Tails…there aren’t any

  11. Breakdown Voltage vs. Temp

  12. Current vs. Voltage by temp.

  13. Noise vs. Voltage by temp.

  14. Issues … • Cooler plate must not be left floating • Electrically connect to board

  15. Future Plans • Measure noise with powered APD  • Measure noise with APD vs. Temperature  • Gain measurement with Temperature • Measure noise as a function of Tint • Measure LED generated signal • Measure signal from scintillator with trigger • …

More Related