WWiSE Group Partial Proposal on Turbo Codes

1. WWiSE Group Partial Proposal on Turbo Codes August 13, 2004 Airgo Networks, Bermai, Broadcom, Conexant, STMicroelectronics, Texas Instruments WWiSE group

2. WWiSE contributors and contact information • Airgo Networks: VK Jones, vkjones@airgonetworks.com • Bermai: Neil Hamady, nhamady@bermai.com • Broadcom: Jason Trachewsky, jat@broadcom.com • Conexant: Michael Seals, michael.seals@conexant.com • STMicroelectronics: George Vlantis, George.Vlantis@st.com • Texas Instruments: Sean Coffey, coffey@ti.com WWiSE group

3. Contents • Overview of partial proposal • Motivation for advanced coding • Specification of turbo code • Performance results • Summary WWiSE group

4. Overview of partial proposal • The WWiSE complete proposal contains an optional LDPC code to enable maximum coverage and robustness • FEC coding fits into the system design in a modular way, and in principle any high-performance code could be used instead of the LDPC code • This partial proposal highlights an alternative choice for optional advanced code • The system proposed is identical to the WWiSE complete proposal in all respects except that the optional LDPC code is replaced by the turbo code described here WWiSE group

5. Motivation for advanced coding • Advanced coding translates into higher achievable throughput at the same robustness • In particular, in most configurations the BCC of rate ¾ and turbo code of rate 5/6 have approximately the same performance • Thus advanced coding enables a rate increase from ¾ to 5/6 without robustness penalty • At any given rate, advanced coding enhances coverage and robustness • In addition, the modularity of the design means that the advantages carry over to every MIMO configuration and channel bandwidth WWiSE group

6. Transmitter block diagram Add pilots Turbo encoder, puncturer Interpol., filtering, limiter MIMO interleaver Upconverter, amplifier Symbol mapper IFFT D/A Add cyclic extension (guard) WWiSE group

7. 1+D +D3 Turbo interleaver g(D) = 1+D2+D3 Turbo encoder Systematic bit 1+D +D3 g(D) = Parity bit 0 1+D2+D3 Parity bit 1 These are the constituent codes used in the 3GPP/UMTS standard encoder WWiSE group

8. Turbo code frame format • The data payload is padded to reach a multiple of 512 bits • The result is divided into blocks of 2048 bits and 512 bits • Number of 512 bit blocks is in the range 1-4 • All 512 bit blocks are placed at end of frame • Each block is encoded as a separate turbo codeword WWiSE group

9. Turbo interleaver design • Two interleavers are proposed, one for each supported block size: 2048 and 512 bits • Each interleaver is a contention-free inter-window shuffle interleaver • Designed to minimize memory contention when code is decoded in parallel • Equivalent performance to 3GPP/UMTS interleavers WWiSE group

10. Puncturer • Parity bits are punctured at regular intervals • Puncture intervals: • Systematic & tail bits are not punctured; pad bits are punctured • All code rates are easily derivable from mother code • Other puncturing patterns and setups also work well WWiSE group

11. Puncturing tail codewords • Tailing codewords, i.e., codewords of length 512 information bits, are punctured differently, to a lower code rate • This facilitates low latency decoding: tail codeword blocks are shorter and can be decoded with fewer iterations, without affecting operating point • Puncture intervals for tail blocks: WWiSE group

12. Parallelization of turbo decoders • Parallelization: • Divide trellis into a number of (possibly overlapping) segments and decode each in parallel • Any reasonable number of iterations can be achieved without affecting latency • End-of-packet latency: • To achieve full gains of turbo or any iterative code, it is possible to taper codeword length and rate at end of packet • High throughput naturally requires longer packets and Block Ack . . . Block 3 Block 1 Block 2 WWiSE group

13. Complexity • Compare to state complexity of 64-state BCC decoding equivalent throughput • System assumptions: M-state constituent codes, I iterations, soft-in soft-out algorithm extra cost factor of a, BCC duty factor of b • Decoder must process 2 x 2 x I x b trellis transitions (I iterations, 2 constituent codes, forward-backward for each, less duty factor), each of which costs aM/64 as much • Overall complexity is 4I abM/64 times as much as 64-state code • E.g., with M = 8, I = 7, a = 1.5, b = 0.7, we have 3.675 times the state complexity • This does not account for other differences such as memory requirements and interleaver complexity WWiSE group

14. Performance results WWiSE group

15. Simulation setup • All combinations of: • Channels B, D, AWGN • 20 MHz and 40 MHz • Rate ¾ and rate 5/6 • BCC and turbo code • All simulations under ideal conditions WWiSE group

16. Channel model B NLOS, 20 MHz WWiSE group

17. Channel model B NLOS, 40 MHz WWiSE group

18. Channel model D NLOS, 20 MHz WWiSE group

19. Channel model D NLOS, 40 MHz WWiSE group

20. AWGN, 20 MHz WWiSE group

21. AWGN, 40 MHz WWiSE group

22. References IEEE 802.11 documents: • IEEE 802.11/04-0886-00-000n, “WWiSE group PHY and MAC specification,” M. Singh, B. Edwards et al. • IEEE 802.11/04-0877-00-000n, “WWiSE proposal response to functional requirements and comparison criteria,” C. Hansen et al. • IEEE 802.11/04-0952-00-000n, “WWiSE partial proposal on turbo codes: specification,” S. Pope et al. Parallelization: 4. K. Blankenship, B. Classon, and V. Desai, “High-throughput turbo decoding techniques for 4G,” Int. Conf. on 3G Wireless & Beyond, 2002. 5. E. Yeo, B. Nikolic, and V. Anantharam, “Iterative decoder architectures,” IEEE Communications Magazine, August 2003, pp.132-140 WWiSE group

23. References, contd. 6. Z. Wang, Z. Chi, and K. K. Parhi, “Area-efficient high-speed decoding schemes for turbo decoders,” IEEE Trans. VLSI Systems, vol. 10, no. 6, pp. 902-912, Dec. 2002 • S. Yoon and Y. Bar-Ness, “A parallel MAP algorithm for low latency turbo decoding,” IEEE Communications Letters, vol. 6, no. 7, pp. 288-290, July 2002 Interleavers: 8. A. Nimbalker, K. Blankenship, B. Classon, T. Fuja, and D. Costello, “Inter-window shuffle interleavers for high-throughput turbo decoding,” Proc. Int. Symp. on Turbo Codes, 2003. 9. A. Nimbalker, K. Blankenship, B. Classon , T. Fuja, and D. Costello, “Contention-free interleavers,” Proc. Int. Symp. on Info. Theory, 2004. WWiSE group