1 / 10

GE System I/O

GE System I/O . MAIN 222 Industrial Controllers. Introduction . See Unit 4 Course Manual Info %I is an input %Q is an output %M is an internal bit An internal bit is a contact or location that is memory / virtual in nature. Contacts.

cameo
Download Presentation

GE System I/O

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. GE System I/O MAIN 222 Industrial Controllers

  2. Introduction • See Unit 4 Course Manual Info • %I is an input • %Q is an output • %M is an internal bit • An internal bit is a contact or location that is memory / virtual in nature

  3. Contacts • A contact is used to monitor the state of a machine or internal reference. • Whether or not the contact passes “flow” depends on status of the reference being monitored and type of contact. Normally Open = Reference is On 1 Normally Closed = Reference is Off 0

  4. Contacts • Types of Coils • Unit 9-5 HO • Retentive • Non-retentive • Power Off then Back On Stays the Same That is Retentive • SET • RESET

  5. Types Of Contacts • %Q • Discrete machine outputs • Non-Duplicated • %M • Internal Discrete References • Not Retentive • Can be Duplicated • %T • Temporary Internal References • Not Retentive • Can be Duplicated

  6. Relay Elements • Unit 9-7 • Go over 9-8 Example

  7. Addressing Systems • Siemens • E = In • A = Out • GE • I = In • Q=Out • TI • X = In • Y = Out

  8. Write A logic Program

  9. Writing Programs Basics

  10. Where to Get More Information • See Web Site • VersaPro 2.02/3 users guide • Unit 2,4,9 from Series 90-30 Course Manual HO

More Related