1 / 8

WLNN-ER-DP551 Template

WLNN-ER-DP551 Template. Step 1 -. By default the unit is in ethernet role – router with eth dhcp server enabled. This means the device you are plugged into will receive a 192.168.2.XXX address. Right click on the device you want to load the template to. Step 2 -.

channing-massey
Download Presentation

WLNN-ER-DP551 Template

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. WLNN-ER-DP551Template

  2. Step 1 - By default the unit is in ethernet role – router with eth dhcp server enabled. This means the device you are plugged into will receive a 192.168.2.XXX address.

  3. Right click on the device you want to load the template to. Step 2 -

  4. Verify that your unit applied the template by right clicking on the device choosing template management. You should have an option that allows you to stop using the template. Step 3 -

  5. Apply the template configuration to the device. Step 4 -

  6. Close the Airborne Management Center. Be sure to Save your changes! Step 5 -

  7. When you reopen the Airborne Management Center you should see the device listed with the BridgeTemplateEnterprise with a ETH-IP of 169.254.2.100. The ethernet now adapts a auto ip address of your NIC LAN card. Step 6 -

  8. You should now be able to access the web interface and see the defaults as listed above. When a factory reset is done it will lead you back to these defaults and not the original ETH role router defaults. Step 7 -

More Related