70 likes | 80 Views
<br>300-101 dumps does not need too much hard work but it has been designed for smart study.You can get handsome grades in your final by using this study material. It is just one click away from Realexamcollection.Information in this material has been presented in a way that you get all the required knowledge of the field from this one source.All the requirements of the exam have been considered to produce the best possible results.300-101 dumps material comes with money back guarantee.https://www.realexamcollection.com/cisco/300-101-dumps.html
E N D
Cisco Exam 300-101 Implementing Cisco IP Routing Version: Demo [ Total Questions: 10 ] https://www.realexamcollection.com/cisco/300-101-dumps.html
Topic break down Topic No. of Questions Topic 4: VPN Technologies 3 Topic 5: Infrastructure Security 1 Topic 6: Infrastructure Services 2 Topic 7: Mix Questions 4 2
Topic 4, VPN Technologies Question No : 1 - (Topic 4) A company has just opened two remote branch offices that need to be connected to the corporate network. Which interface configuration output can be applied to the corporate router to allow communication to the remote sites? A. interface Tunnel0 bandwidth 1536 ip address 209.165.200.230 255.255.255.224 tunnel source Serial0/0 tunnel mode gre multipoint B. interface fa0/0 bandwidth 1536 ip address 209.165.200.230 255.255.255.224 tunnel mode gre multipoint C. interface Tunnel0 bandwidth 1536 ip address 209.165.200.231 255.255.255.224 tunnel source 209.165.201.1 tunnel-mode dynamic D. interface fa 0/0 bandwidth 1536 ip address 209.165.200.231 255.255.255.224 tunnel source 192.168.161.2 tunnel destination 209.165.201.1 tunnel-mode dynamic Answer: A Question No : 2 - (Topic 4) Which common issue causes intermittent DMVPN tunnel flaps? A. a routing neighbor reachability issue B. a suboptimal routing table C. interface bandwidth congestion D. that the GRE tunnel to hub router is not encrypted Answer: A 3
Question No : 3 - (Topic 4) Which encapsulation supports an interface that is configured for an EVN trunk? A. 802.1Q B. ISL C. PPP D. Frame Relay E. MPLS F. HDLC Answer: A Topic 5, Infrastructure Security Question No : 4 - (Topic 5) Which address is used by the Unicast Reverse Path Forwarding protocol to validate a packet against the routing table? A. source address B. destination address C. router interface D. default gateway Answer: A Topic 6, Infrastructure Services Question No : 5 - (Topic 6) When a packet is denied by an IPv6 traffic filter, which additional action does the device perform? A. it scans the rest of the ACL for a permit entry matching the destination. B. It generates a TCP Fin bit and sends it to the source. 4
C. A creates a null route for the destination and adds it to the route table. D. It generates an ICMP unreachable message for the frame. Answer: D Question No : 6 - (Topic 6) What is the purpose of configuring the router as a PPPoE client? A. to provide VPN access over L2TP B. to enable PPP session from the router to the termination device at the headend for metroEthernet connectivity C. for DSL connectivity and removing the need for the end-user PC to run the PPPoE client software D. for connecting the router to a cable modem, which bridges the Ethernet frames from the router to the cable modem termination system Answer: C Explanation: DSL Technology used PPPoE protocol (service provide end) and user end required to be used same Protcol running as client to communicate with it Topic 7, Mix Questions Question No : 7 - (Topic 7) Which two BGP neighbor states are valid? (Choose Two) A. established B. active C. stuck in active D. 2-WAY 5
E. unknown F. DROTHER Answer: A,B Question No : 8 - (Topic 7) A network administrator is troubleshooting a DMVPN setup between the hub and the spoke. Which action should the administrator take before troubleshooting the IPsec configuration? A. Verify the GRE tunnels. B. Verify ISAKMP. C. Verify NHRP. D. Verify crypto maps. Answer: A Question No : 9 - (Topic 7) The OSPF database of a router shows LSA types 1, 2, 3, and 7 only. Which type of area is this router connected to? A. stub area B. totally stubby area C. backbone area D. not-so-stubby area Answer: D Question No : 10 - (Topic 7) What’s uRPF checking first when the packet enters the interface ? or when unicast reverse patch forwarding is configured on interinterface. A. it check the ingress access list B. it check the egress access list 6
C. Route available in FIB ot it verifies a reverse patch via the fib to the source D. it verify that the source has a Answer: C https://www.realexamcollection.com/cisco/300-101-dumps.html 7