1 / 11

1401 Valley View Lane Irving, TX 75061

www.omega-usa.com. 1401 Valley View Lane Irving, TX 75061. 41-15208 Test Tool for Externally Controlled Compressors. JANUARY 2010. Denso and Sanden compressors can be tested with the CLT. Denso: 7SEU16 6SEU14 5SE09C. Sanden: PXE 13 PXE 16. 7SEU17 6SEU16 5SER09.

dannycooper
Download Presentation

1401 Valley View Lane Irving, TX 75061

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. www.omega-usa.com 1401 Valley View Lane Irving, TX 75061 41-15208 Test Tool for Externally Controlled Compressors JANUARY 2010

  2. Denso and Sanden compressors can be tested with the CLT • Denso: • 7SEU16 • 6SEU14 • 5SE09C • Sanden: • PXE 13 • PXE 16 • 7SEU17 • 6SEU16 • 5SER09 These models can be found in BMW, Mercedes, Toyota and VAG cars

  3. Piston Shoe Pin Main shaft Rotor Mechanical torque limiter EMPCV No Clutch Reduce spring Orifice Cam Swash plate The valve is regulated by the board electronic…. …these signals are hard to measure

  4. CLT1 supports two areas • Identifying the root cause • Right Diagnosis • Systematical search • Minimizing the costs • Service level • Quicker service • Better cost coverage

  5. The tester improves the diagnosis and thereby save money • It eliminates the wrong diagnosis • You do not need to guess • It saves time • The variable area of the compressor can be tested. • It saves money

  6. You can run the compressorwithout removing it! • Just jack out the compressor connector • Connect simulator on the free cable • Connect CLT to the compressor • Connect Power supply to the vehicle battery •  The compressor is now ready to be run and pressure to be tested

  7. The simulator prevent the board electronic to generate and save fault messages Clearing the fault memory is a time consuming activity avoided by connecting the simulator

  8. The CLT 1 is easy to connect Compressor cable Power supply cable 2-polig 3-polig

  9. Open circuit and over load are directly indicated OC = ”Open Circuit” = ”Poor contact.Carefully knock 2-3 times on the valve The diode still indicates – change compressor OL = ”Over Load” = Short cut Change compressor directly

  10. Control the compressor effect with the CLT Time consumption:5 min to connect everything. Max 10 to test! Result within 15 minutes!!! Change the effect with the + / - buttons. You can directly see if the compressor react or not!

  11. CLT1 – Delivery content

More Related