Download
1 / 48
480 likes | 622 Views
The PowerMax Pro. The PowerMax Pro. The PowerMax Pro Partition. The PowerMax Pro Access Code. The PowerMax Pro. It has 30 zones; Each zone is identified by a number and a name
E N D
The PowerMax Pro • It has 30 zones; Each zone is identified by a number and a name • It has 4 partitions (optional, can be ignored); each partition can be viewed as a security system by itself • Six arming modes1. Away2. Away Instant3. Home4. Home Instant5. Latchkey6. Bypass • Lights and electrical appliances can be controlled if optional X-10 modules are used.
The PowerMax Pro • Looking after elderly, physically handicapped and infirm individuals: The system can be programmed to monitor activity within the protected area and send out an alert message if the person under surveillance remains still for a predefined period of time (as set by your installer). • Distress calls: Miniature pushbutton transmitters dealt out to specific individuals may be used for sending emergency calls for help. • Disarming under duress: If a user is forcibly compelled to disarm the system, he can use a special code that disarms the system apparently as usual, but sends a silent alarm to the central station
Enrolling a Device • To enroll a device means to link a device to the controller, eg, enroll a wired contact, enroll a wireless sensor, etc • When asked to Delete using the OFF key,Use the Disarm button
During enrolling, you may seea black rectangle; it means the device has been enrolled by someone else.Hit [OFF] key to delete. Black rectangle
Enroll one device to one zone.If u enroll two devices to one zone,the previous device will be disabledEg, wired contacts to zone 29,wireless contacts to zone 30
Activate device at this point, eg, open contacts Note : Wired device enrolling does not have “Transmit now” display
What difference in steps did you notice between enrolling wired and wireless devices?
Once a device is enrolled, the controller can detect it. • If you have enrolled the magnetic contacts, open the contacts and observe what is displayed on the LCD display, such as, “ Back Door Open” This confirms that the controller is able to detect the contacts – enroll successful
After Enroll, do not delete unless you want to unlink the device This black rectangle shows that You have enrolled the device
How to delete Enrolled Zone You may wish to delete an enrolled device later for some reasons. The next section is on this.
After Deletion, the black rectangle disappears After Delete
Diagnotics Checking if devices Are Functioning properly
Diag. Testing 10. Diagnostics WL Sensors Test Open door Z01 NOT-OK Front Door Perform Diagnostic Test of Wireless Devices Fail PASS Open door Z01 STRONG Front Door
01 Zone no: 3. Define Zone Zone No : 01 Z01: TYPE -- 2. Perimeter Done! Z01: NAME -- Back door Done! How to change Zone Type How to change Zone Name How to change Chime Z01: CHIME Chime OFF Done! Partition 1 Z01: PARTITION Done!
Enrol Proximity Tag • EnrolEnrolProg Tag <ok> • Tag No 1 <ok> Present Tag: Tag No 1 <next> • To return click “home” <ok> to exit
Define Control Panel • Installer Mode <next> • Define Panel <Ok> • Entry Delay 1
After Enroll After Delete Observation
Entry Delay setting • Installer Mode • 4. Define Panel • 01 Entry Delay 1 [Press OK] • Choose 15s This is the time given for a person to open the door, and go and disarm the controller. There are two Delays 2 choose from.
Exit Delay setting • Installer Mode • 4. Define Panel • 02 Entry Delay 1 [Press OK] • Choose 60s (60s after arming button pressed, then controller is activated) This is the time given for a person to arm the controller, go to the main door, lock it.
