1 / 15

VLSI Digital System Design

Input-Output Pads. VLSI Digital System Design. Input-Output Pad Design. I-O pad design is highly specialized Requires circuit design experience Requires fabrication process understanding Choose already-characterized library from: Fabrication vendor Third-party library vendor

edmund
Download Presentation

VLSI Digital System Design

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Input-Output Pads VLSI Digital System Design

  2. Input-Output Pad Design • I-O pad design is highly specialized • Requires circuit design experience • Requires fabrication process understanding • Choose already-characterized library from: • Fabrication vendor • Third-party library vendor • In-house group

  3. Pad Size and Spacing • Pad size • Smallest to which a wire can be bonded • 100 – 150 μm • Pad spacing • Smallest to which a bonding machine can bond • 150 – 200 μm

  4. I-O circuitry Interdigitated Pads • Allows more pads on die

  5. IBM C4 I-O Pads • Bonding wires restrict I-O pads to die edge • IBM C4 I-O pads can also be on interior of chip • Deposit solder ball on I-O pad • Heat die and board to reflow solder • Solder surface tension positions die on board

  6. Latchup • Latchup occurs when voltage excursion outside VSS < v < VDD • Most likely at I-O pad • Large transistors • High current • Inductance of bonding wire • Connection to external circuitry

  7. Output Pad Latchup Prevention • Separate the nMOS and pMOS transistors • Separate the power supplies for I-O frominternal logic • Guard rings

  8. Guard Rings • Ohmic contacts to metal • p+ diffusion in p-substrate • n+ diffusion in n-well • Collect minority carriers • Injected into substrate whendrain diodes are forward-biased • Rings should be continuous diffusion • No crossovers

  9. Double Guard Rings • Surround nMOS transistor by: • p+ connection to VSS, surrounded by • n-well with n+ connection to VDD • Surround pMOS transistor by: • p+ ring connected to VDD, surrounded by • n-well with n+ connection to VSS

  10. Use Smaller Transistors in Parallel • Minimize gate • Reduce RC delay • I-O pad transistors often have long gates • Improve avalanche breakdown characteristics • Parallel metal-transistor connections • Minimize metal migration

  11. Input PadElectrostatic Discharge Protection R X Inputpad

  12. Input Pad ESD Protection • If not VDD <= X <= VSS,one of the clamp diodes turns on • Use double guard rings • Resistor R limits current in clamp diode • 200 Ω <= R <= 3000 Ω • Tub resistor • For n-well process: p-diffusion • C is input capacitance • Speed of signal limited by RC

  13. Alternative Input Pad ESD Protection R X Inputpad

  14. Punch-Through Device • Built of closely-spacedsource and drain diffusions • No gate • “Avalanches” at c. 50 V

  15. Pull-Up or Pull-Down Resistor • Long pMOS transistor • Long nMOS transistor • Connect gate to signal for IDDQ testing

More Related