70 likes | 84 Views
H-jet Run at Injection A. Dion, H. Huang, A. Poblaguev, A. Zelenski, and YM. What was done. The Jet ran quite well with near maximal intensity 4700 counts.
E N D
H-jet Run at InjectionA. Dion, H. Huang, A. Poblaguev, A. Zelenski, and YM
What was done • The Jet ran quite well with near maximal intensity 4700 counts. • Started at noon with the Blue beam and adjusted the jet timing so that the elastic scattering banana falls on the correct time / Energy curve. • Within 1 hour decided to inject the Yellow beam and separated the two my ~ 3 mm. By 5:30 pm we up and running. • Took 1-hr runs with polarimeter runs with jet running till we realized that this may corrupt the data (increased bkgnd). Shifted to two hour runs with Polarization measurements with DAQ off. • Two-beam store was dumped around 11 pm. • Ran till 8 am with single blue beam.
Running with single Beam Good background Prompts approaching the data near 3-4 MeV recoil energy The bunch length is much wider that we have seen at 100 or 250 GeV
Run with Two beams • Running with two beams separated by 3 mm vertically. • Adjusted beams vertical position for uniform acceptance • Background higher
From the online monitoring • The bananas for Blue and Yellow beams same scale. • Bunch length is significantly shorter • @ 250 GeV
Results (not ready) • We need to adjust our cuts compared to what we have been using • A quick look indicates significant fluctuations from short 1-2 hr. runs. Need to inspect and fine tune our cuts. • Depending on our (energy) cuts we think we should have enough data for a 5% measurement • My only suspicion is whether the beams were properly centered on the jet • Stay tuned.