Step-by-Step Guide to Brick Wall Cutting

1. Step-by-Step Guide to Brick Wall Cutting Thinking of a brick wall cutting to make an opening for a chimney, window, or perhaps a door? Worry not! It isn’t as tricky as it appears on the outside. All you need is a little planning and a few steps to accomplish it. If you are skeptical about doing it yourself, follow the stepwise guide we have compiled for you to give a quick idea of how it is done with minimal tools and effort. Before proceeding any further, ensure the project you are attempting to start doesn’t involve a Structural Wall Removal. Load-bearing walls are the foundation of your structure and shouldn’t be given any jolt or hit without the pre-consultation of the field experts. Also, If you are planning to do a DIY brick wall cutting, make sure you have pre-calculated the risks and consequences of digging an opening into the wall and have secured yourself from all sides. Any lapse in the order or method of performing the brick wall cutting can cost you heavy damages. So the best way is to start with a smaller project and get your basics right before attempting to do it in the prominent place of your house.

2. Here are the steps you must follow to do the Brick Wall Cutting Prepare a Blueprint The first and foremost step is to prepare a blueprint in your mind. Depending upon your requirement, whether you want to dig a hole for a window, a door, or a fireplace, you must take note of the special measurements and depth involved. Remember that once it is acted upon, you won’t be able to undo it, so be very sure of the specifications and prepare to proceed with proper tools, following a diligent approach. Mark the Area The next step is to carefully mark the area where you want to dig an opening. Do the proper analysis and be very sure about the measurement and depth of the wall opening you are trying to make. To follow a proper procedure, you must use the spirit level to make sure the lines you are drawing are in correct alignment. Also, don’t forget to install the lintel to provide sufficient support to the rest of the wall. Ensure you follow these steps in the correct sequence, so you don’t regret running the angle grinder in the wrong angle. Do the Necessary Preparations Since Brick Wall Cutting involves a lot of dust and debris, make sure you wear safety gear like gloves, masks, and safety glasses to stay alert and comfortable while performing the task. Also, you may cover the furniture or other stuff lying around the area to ensure they remain dust-free. Prepare to Cut Opening in the Wall Once you are done marking the area, now is the time to get into the real action and run an angle grinder along the marked lines. You don’t have to apply much force onto the grinder and allow it to cut through the wall at its own pace. After grinding the outer boundary, attempt to loosen the mortar and bricks within the marked area and pull the bricks out with the help of a hammer drill. Lastly, ensure you do not hit the drill with excessive force, as you may end up breaking the outer edges of the wall while attempting to hollow the brick surface. Remove Bricks and Do the Final Touches The final step is to remove bricks and mortar from the opening and clean it with sandpaper. Now you can do the final touches, and the wall opening is ready for whatever purpose you’ve dug it for.

3. Conclusion So that was the whole procedure of brick wall cutting from scratch to end. You may simply attempt it yourself if the area and location aren’t sensitive enough to require an expert’s intervention. Otherwise, it’s recommended to seek the professional’s assistance since they are trained and well equipped with all that’s needed to perform the procedure of brick wall cutting with absolute ease and expertise. We hope this article provided the necessary insights to perform this task, and see you soon with some other relevant pieces of information. Source: - https://www.livewebdigital.com/brick-wall-cutting/