1 / 18

Installation guide for RG6/59 compression connectors

Learn how to install RG6/59 compression connectors with step-by-step instructions and the necessary tools. Achieve the finest connection for your cable installation project.

enriquetaj
Download Presentation

Installation guide for RG6/59 compression connectors

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Installation guide for RG6/59 compression connectors

  2. To begin with – we need some tools… Cabelcon Rotary Stripper Cable cutter Mounting tool Please read the instructions before using the tools! Compression tool Rubber tool

  3. Let’s start to work… First step is to cut your cable using a proper cable cutter.

  4. Strip your cable… Insert the cable into the cable stripper as shown… Attention: Please make sure to adjust the tool blades for your cable dimensions before using it for the first time! Please read instructions supplied with the tool. Screws for adjustment of blades Hex tool for adjustment

  5. Strip your cable… Turn the stripper clockwise 4-5 times…

  6. Strip your cable… - and pull to remove the scraps…

  7. Strip your cable… Optional: You can check the stripping dimensions against the guide printed on the connectors 6,5 + 6,5 mm (¼” + ¼”)

  8. Prepare your cable… Fold exposed braid over the jacket. Leave the inner foil attached to the dielectric and make sure that the foil is undamaged and smooth. For ”Quad shield”, ”Tri shield” and ”Super shield” cables: Remove the outer braid and foil only. Fold back the inner braid.

  9. Mount the connector… Use of the Rubber Tool will ensurean excellent grip on the cable! * Press the front part of the connector (with the built-in ”tool”) against the cable and turn it slowly to prepare the foil to enter into the connector.(* Optional operation – normally not necessary if Corning Cabelcon’s Rotary Cable Stripper has been used)

  10. Mount the connector… Push the connector over the foil and allow the support mandrel to slide between the foil and braid… A mounting tool can be used to ensure a better grip on the connector…

  11. Mount the connector… Press and turn until the dielectric is flush with the support mandrel face

  12. Compress the connector… 1) Insert your connector/cable into the tool with the tool handle in open position… Click! 2) Apply a downward pressure on the cable to allow the split jaws to secure the cable…

  13. Compress the connector… Beforecompression Aftercompression - and close the tool handle completely insuring the connector sleeve is fully compressed (white plastic is invisible).

  14. Take out the connector… Open the tool - press the outside split-jaw tabs and pull out the connector assembly…

  15. Compression completed The finest connection available!

  16. More tools available… Other types of tools are available. A few examples: Universal tool for RG6/59 and RG11 Corning Cabelcon universal CX3 compression tools Various installation tools Please checkout our website www.cabelcon.dk for more information

  17. Finally some good advice… In order to avoid decreased network performance, we recommend the use of a torque wrench to ensure proper tightening of your connectors. 1. 2.

  18. January 2008

More Related