60 likes | 76 Views
AO Series 10 Illuminator pattern with cover . Replaces Mirror mount. 3. 4. 2. 2. 5. 1. 1. 5. This cover could be wider if you Have more room. Cardboard mock up of full cover pattern. Cover could be larger Than pattern shows- but I drew ‘tight’ so I could get two from
E N D
AO Series 10 Illuminator pattern with cover. Replaces Mirror mount. 3 4 2 2 5 1 1 5 This cover could be wider if you Have more room.
Cardboard mock up of full cover pattern. Cover could be larger Than pattern shows- but I drew ‘tight’ so I could get two from the Wal Mart cookie sheet. Hand holding a CF ballast, and ballast mounted. Ballast covers are removed, and the spool flanges trimmed just bit, to fit.
5 2 1 AO Series 10 Illuminator Cutting patterns- One piece base, partial cover Replaces mirror mount in base. 3 4 2 1 5
Cardboard mock up w/ cover in place. Note that tail of cover goes under fold in the back- so offset the bend-over on the back, to allow clearance. Cover attaches with sheet metal screw(s) in the back, and in front, the tabs catch the mirror mount screws. An example of the earlier pattern cut and bent up. Ballast can be under cover, but some insulated wiring is exposed. Ballast should be used with it’s cover.