1 / 21

Atmospheric phase correction for ALMA

Atmospheric phase correction for ALMA. Alison Stirling John Richer Richard Hills University of Cambridge Mark Holdaway NRAO Tucson. ALMA Goal. To achieve: Diffraction-limited operation at sub-mm wavelengths on baselines up to 14 km. Corresponds to 0.01 arcsec resolution requirement

gerard
Download Presentation

Atmospheric phase correction for ALMA

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Atmospheric phase correctionfor ALMA Alison Stirling John Richer Richard Hills University of Cambridge Mark Holdaway NRAO Tucson

  2. ALMA Goal To achieve: • Diffraction-limited operation at sub-mm wavelengths on baselines up to 14 km • Corresponds to 0.01 arcsec resolution requirement • To achieve at ALMA’s highest frequencies (~950 GHz), require phase errors < 50 microns on baselines of 14 km • Typical atmospheric phase fluctuations at Chajnantor: 90-400m on 300m baselines at 25-75% level • Corresponds to fluctuations of ~300-1200m at 14km Atmospheric phase correction essential

  3. Atmospheric phase dependence Atmospheric phase fluctuations in sub-mm caused by variations in water vapour and air density

  4. Phase correction strategy To use a combination of: • Fast switching • Measure phase from a nearby point source calibrator • Measures total atmospheric phase • Intermittent (every ~10s of seconds) • Gives phase along a different line of sight • Water vapour radiometry • 183 GHz radiometers four channels • Only sensitive to wet component • Continuous, on source • Two prototype WVRs built by Cambridge and Onsala now ready for testing

  5. Correction Strategy Issues • How often to switch to a calibrator? • Time spent on calibrator? • Angular distance to calibrator? • Smoothing time for WVR brightness temperatures? • Calculation of conversion factor for WVR?

  6. Correction Strategy • Answers depend in detail on atmospheric structure, e.g. • Ratio of wet to dry phase fluctuations • Phase structure function • Also depends on • Instrumental noise (antenna and WVR) • Distribution and brightness of point source calibrators Aim of work: to simulate realistic atmospheric phase fluctuations for the Chajnantor site Day time: 390-1000 m (on 300 m baselines) Night: 90-290m Need separate analysis for day and night time conditions

  7. Met Office Large Eddy Model • Solves Navier-Stokes equation on a grid • Assumes a Kolmogorov energy cascade on sub-grid scales • Models water vapour, temperature, pressure • Two scenarios: • daytime -- convection from surface heating • night time -- wind shear induced turbulence

  8. Daytime profiles

  9. 1.2 . Height / km 0 -2.5 Horizontal distance / km 2.5

  10. 2.5 Y / km -2.5 -2.5 X /km 2.5

  11. Location of dry, wet and total refractive index fluctuations Significant anticorrelation between dry and wet Fluctuations at the temperature inversion.

  12. Estimation of fluctuations from radiosonde profiles Solid = total, Dotted wet, Dashed = dry * = Interferometric measurements of total daytime rms phase (Evans et al, 2003) At 50% level: • Dry: 200 microns • Wet: 400 microns • Total: 400 microns • Independent confirmation of phase fluctuation amplitude • Initial estimates of dry fluctuation component

  13. Daytime structure function • Solid = dry • Dot dashed = wet • Dotted = cross-correlation term • Consistent with Kolmogorov spectrum on small scales

  14. Nocturnal mean profiles Gradient of temperature profile opposite sign from water vapour profile

  15. Evolution of night time fluctuations 0.6 Height / km 0 Horizontal distance / km -0.3 0.3

  16. Location of dry, wet and total refractive index fluctuations Negative correlation between wet and dry fluctuations near ground

  17. Nocturnal structure function • Blue dashed = wet; black solid = dry • r.m.s. wet fluctuations ~ 2 x r.m.s dry • Exponent of wet: 1.0, dry: 0.8 • Turn over around 800m (~ depth of layer)

  18. Simulations of phase correction • AIPS++ code written by Mark Holdaway • Combines Mark’s fast switching simulator with our 3-D simulations of atmosphere • WVR simulated using `am’ radiative transfer code to calculate brightness temperatures (Scott Paine)

  19. Correction process: WVR

  20. WVR: rms error

  21. Conclusions • Now have realisations of the atmosphere at Chajnantor for day and night conditions • Dry and wet fluctuations have different distributions depending on time of day • Have developed simulations of FS+WVR phase correction • Future plans: • Investigate different phase correction strategies • Validation of the two ALMA prototype WVRs on SMA

More Related