1 / 6

Flow control to “None”

Step 1. Configure Hyper-terminal to communicate with SC serial interface through Com 1 serial port. Connection speed at 115200. Flow control to “None”. Step 2A. Configure Hyper-terminal to communicate with SC serial interface through Com 1 serial port. 132 column mode. Emulation VT100.

ince
Download Presentation

Flow control to “None”

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Step 1. Configure Hyper-terminal to communicate with SC serial interface through Com 1 serial port Connection speed at 115200 Flow control to “None”

  2. Step 2A. Configure Hyper-terminal to communicate with SC serial interface through Com 1 serial port 132 column mode Emulation VT100 ASCII

  3. Step 3. Push Reset button or Turn Abacus50 Off then ON to restart system

  4. Step 4. Before count down to zero, press any key to stop auto booting procedure

  5. Step 5. The HyperTerminal window will display four options, change the network configuration and save settings

  6. Step 6. After updating, Abacus will reboot and you can check the new configurations during boot procedure

More Related