Download
1 / 56
620 likes | 877 Views
Electrodynamics. Electromotive Force Electromagnetic Induction Maxwell’s Equations.
E N D
Electrodynamics • Electromotive Force • Electromagnetic Induction • Maxwell’s Equations
Problem: A cylindrical resistor of cross-sectional area A and length L is made from material with conductivity σ. If the potential is constant over each end, and the potential difference between the ends is V, what current flows?
Ohm’s Law: V=IR
a b σ Problem 7.1 Two concentric metal spherical shells, of radius a and b, respectively, are separated by weakly conducting material of conductivity σ.
…(a) if they are maintained at a potential difference V, what current flows from one to the other?…(b) What is the resistance between the shells?
x h R v Motional EMF:
L R v m Problem 7.7 A metal bar of mass m slides frictionlessly on two parallel conducting rails a L apart . A resistor R is connected across the rails and a uniform magnetic field B, pointing into the page fills the entire region.
L R v m (a) If the bar moves to the right at speed v, what is the current in the resistor? In what direction does it flow?(b) What is the magnetic force on the bar? In what direction?
L R v m (c) If the bar starts out with speed v0 at time t = 0, and is left to slide, what is its speed at a later time t ? (d) Check that the energy delivered to the resistor is exactly equal to the initial kinetic energy ?
a a s I Problem 7.8 A square loop of wire (side a) lies on a table, a distance s from a very long straight wire, which carries a current I, as shown below,
(a) Find the flux of B through the loop.(b) If someone now pulls the loop directly away from the wire, at speed v, what emf is generated? In what direction does the current flow?(c) What if the loop is pulled to the right at speed v, instead away?
ω B a Problem 7.10 A square loop (side a) is mounted on a vertical shaft and rotated at angular velocity ω. A uniform magnetic field B points to the right. Find the ε(t) for this alternating current generator?
Electromagnetic Induction:Faraday’s Law B v v B B Changing Magnetic Field
Lenz’s Law: … the sole purpose it to keep the track of the right direction of induced current.
The Jumping Ring Demonstration Ring Solenoid
Problem 7.12 A long solenoid, of radius a, is driven by an alternating current, so that the field inside is sinusoidal: A circular loop of wire, of radius a/2 and resistance R, is placed inside the solenoid, and coaxial with it. Find the current induced in the loop, as a function of time.
Problem: 7.13 A square loop of wire, with sides of length a, lies in the first quadrant of the x-y plane, with one corner at the origin. In this region there is a non-uniform time-dependent magnetic field, where, k is a constant. Find the emf induced in the loop.
B(t) s Problem: A uniform magnetic field B(t), pointing straight up, fills the shaded circular region as shown below. If B is changing with time, what is the induced electric field?
B0 Problem: A line charge λ is glued onto the rim of a wheel of radius b, which is then suspended horizontally as shown below. In the central region, out to radius a, there is a uniform magnetic field B0, pointing up. Now, someone turns the field off. What happens?
L s s0 Problem: An infinitely long straight wire carries a slowly varying current I(t). Determine the induced electric field, as a function of the distance s from the wire. I
a R Problem 7.17 A long solenoid of radius a, carrying n turns per unit length, is looped by a wire with resistance R as shown below:
(a) If the current in the solenoid is increasing at a constant rate (dI/dt=k), what current flows in the loop, and which way does it pass through the resistor?(b) If the current I in the solenoid is constant but the solenoid is pulled out of the loop, turned around, and reinserted, what total charge passes through the resistor?
Loop 1 I Inductance Loop 2
I a b L Problem: A short solenoid (length L and radius a, with n1 turns per unit length) lies on the axis of a very long solenoid (radius b, n2 turns per unit length) as shown below. Current I flows in the short solenoid. What is the flux through the long solenoid ?
I …The Self Inductance
Problem: Find the self-inductance of a toroidal coil with rectangular cross-section (inner radius a, outer radius b, height h), which carries a total of N turns.
Toriodal Coil …a circular ring, or “donut” around which along wire is wrapped. ..the winding is uniform and tight enough so that each turn can be considered a closed loop.
Problem : 7.20 A small loop of wire (radius a) lies a distance z above the center of a large loop of (radius b), as shown below. The planes of the two loops are parallel, and perpendicular to the common axis. a z b
(a) Suppose current I flows in the big loop. Find the flux through the little loop.(b) If current I flows in the little loop. Find the flux through the big loop. (c) Find the mutual inductances.
Problem 7.22: Find the self-inductance per unit length of a long solenoid, of radius R, carrying n turns per unit length.
I b a I z Problem: A long coaxial cable carries current I (the current flows down the surface of the inner cylinder, radius a, and back along the outer cylinder, radius b) as shown below. Find the magnetic energy stored in a section of length l.
a2 a1 rs Problem 7.30 Two tiny wire loops, with area a1 and a2, are situated a displacement rs apart.
(a) Find their mutual Inductance.(b) Suppose a current I1is flowing in loop 1, and we propose to turn on a current I2 in loop 2. How much work must be done, against the mutually induced emf, to keep the current I1 flowing in loop 1?
Problem 7.29 Suppose the circuit in the given figure has been connected for a long time when suddenly, at time t=0, switch S is thrown by passing the battery. A s B L ε0 R
(a) What is the current at any subsequent time t ?(b) What is the total energy delivered to the resistor?(c) Show that it is equal to the energy originally stored in the inductor.
Problem 7.31 A fat wire, radius a, carries a constant current I, uniformly distributed over its cross-section. A narrow gap in the wire, of width w<<a, forms a parallel-plate capacitor, as shown below. Find the magnetic field in the gap, at a distance s<a from the axis.
w I a I
Problem 7.32…. for a more realistic model, imagine thin wires that connect to the centers of the plates. Again, the current I is constant , the radius of the capacitor is a, and the separation of the plates is w<<a. Assume that the current flows out over the plates in such a way that the surface charge is uniform, at any given time, and is zero at t=0.
w a I I
(a) Find the electric field between the plates, as a function of t. (b) Find the displacement current density Jd?
s I I (c) Repeat it this time for the figure given below:
Problem 7.33 If … • Find the displacement current • density Jd. (b) Integrate it to get the total displacement current,
