1 / 14

FLDIGI Soundcard Calibration

FLDIGI Soundcard Calibration. Wwv mode. George Blakeslee N1GB. Launch FLdigi. Select the WWV modem - Op Mode > WWV. Select the Digiscope - View > Floating Scope. Open Configure > Audio. Choose Devices tab. Check Port Audio Select Input & Output soundcards drop down menu.

jlentz
Download Presentation

FLDIGI Soundcard Calibration

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. FLDIGI Soundcard Calibration Wwv mode George Blakeslee N1GB

  2. Launch FLdigi

  3. Select the WWV modem - Op Mode > WWV

  4. Select the Digiscope - View > Floating Scope

  5. Open Configure > Audio

  6. Choose Devices tab Check Port Audio Select Input & Output soundcards drop down menu

  7. Choose Settings tab Set Sample Rate: Input & Output to Native Set Converter: Best Sync interpolator Will be adjusting the "Rx corr Rate" while observing the slope of the time tick line.

  8. Tune in WWV or WWVH2.5, 5.0, 10.0 or 15.0 MHz

  9. Observe slope of line NEGATIVE POSITIVE

  10. If positive - ADD NEGATIVE value in RX ppm

  11. If negative - ADD POSITIVE value in RX ppm

  12. Repeat until Time Tick is vertical along guide line

  13. Left-click on Time Tick line in Digiscope to center it

  14. Right-click in Digiscope window to zoom 5X

More Related