Real NACE CIP Level 2 NACE-CIP2-001 Exam Questions Killtest - 100% Passing Materials

1. 2020 NACE-CIP2-001 Exam Questions KillTest Coating Inspector Level 2

2. Question 1 You are the NACE Coating Inspector on a tank lining project and are asked to perform a high voltage holiday test after the coating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent. Your first course of action should to: A. Investigate to find the source of the odor B. Don your air supplied respirator and continue the testing C. Exit the tank and immediately and report the problem to the nearest safety supervisor D. Exit the tank and document the incident in your daily report Answer: C

3. Question 2 You are working as an inspector in a galvanizing plant for the first time. What are some of the hazards you need to be aware of: A. Risk of chemical exposure B. Risk of skin C. Risk of acid or caustic splashes D. a), b), and c) Answer: D

4. Question 3 You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved. Your FIRST preferred course of action is to: A. Verbally challenge the NCR B. Request a re-blast of the item in question C. Consult your supervisor D. Review the NCR with the other Inspector Answer: C

5. Question 4 An Inspection and Test Plan is required when: A. It is always required B. When the Coating Applicator requests one C. When the Owner specifies one D. When the Inspector requests one Answer: A

6. Question 5 The Inspectors' goal at the Pre-Job Conference is to: A. Obtain a clear understanding of the Specification B. Discuss contractual requirements C. Manage the meeting so it doesn't go off topic D. Take accurate meeting minutes for distribution Answer: A

7. Question 6 Coating Surveys are legally required: A. On commercial marine vessels and offshore platforms B. On high pressure gas lines and fireproofed structures C. On water tanks and potable water pipelines D. On food and beverage vessels and can linings Answer: A

8. Question 7 The cost of qualified Coating Inspection is normally offset by: A. Lower Application Costs B. Lower Coating Life Cycle Costs C. Lower Safety Enforcement Costs D. Lower Supervision Costs Answer: B

9. Question 8 You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%. Your FIRST preferred course of action is to: A. Check to See if the dehumidification equipment is operating correctly B. Call your supervisor C. Advise the coating applicator supervisor of your readings D. Document the readings at the end of the shift Answer: C

10. Question 9 You are a NACE Level 2 Coating Inspector who has just arrived on a job in progress where there is no Inspection and Test Plan (ITP). The first morning you arrive the job is behind schedule and you are asked to take DIY Film Thickness readings. Your FIRST preferred course of action is to: A. Refuse to take readings until an is in place B. Develop your own methodology and proceed take the readings C. Use a generally accepted industry standard and to take readings D. Call your supervisor Answer: C

11. Question 10 When conducting inspections the Inspector should follow which standards: A. NACE and SSPC standards in North America B. ISO standards in Europe and Asia C. Australian standards in Australia D. The specified standards Answer: D

12. Thank You sales@killtest.com