1 / 10

Tapering of Arrays

Tapering of Arrays. Objective is to reduce the side lobes , which not only the amount of power is wasted in the directions of minor lobes but unnecessary interferences are also caused in those area.

kipp
Download Presentation

Tapering of Arrays

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Tapering of Arrays • Objective is to reduce the side lobes, which not only the amount of power is wasted in the directions of minor lobes but unnecessary interferences are also caused in those area. • Side lobes often termed as “Side lobe ratio” which is the ratio of power density of the main lobes to the power density of longest minor lobes and it is expressed in dB, it is called as “Side-lobe-level”. • The techniques used in “Tapering” is current or amplitudes in the sources of a linear array is non-uniform. • It is found that minor lobes are reduced if the center source radiates more strongly than the end sources and hence this tampering is done from center to end.

  2. The tapering follows coefficients of binomial series and Tchebysceff polynomial

  3. Binomial Arrays • It is a linear array of n- isotropic point sources of non-uniform amplitude. • In this type of array, an amplitudes of the radiating sources are arranged according to the coefficients of successive terms of the following binomial series where n = number of radiating sources in the array. • This work can be accomplished by arranging the arrays in such a way that radiating sources in the center of the broadside array radiated more strongly than the radiating sources at the edges. The secondary lobes can be eliminated entirely, if the following two conditions are satisfied. • Spacing between the two consecutive radiating sources does not exceed and • The current amplitudes in radiating sources (from outer, towards center source) are proportional to the coefficient of the successive terms of the binomial series (Equation-1) • Equation-1

  4. Pascal’s Triangle

  5. It may be noted that Elimination of secondary lobes takes place at the cost of directivity. • HPBW power beam width (HPBW) of binomial array is more than that of uniform arrays for the same length of the array. • For example, for radiating source n=5, spaced apart HPBW of the binomial and uniform arrays are respectively 23 deg. & 31 deg. as shown in figure below • Thus, in uniform array secondary lobes appear but principle lobe (main lobe)is sharp and narrow where as in binomial array width of beam widens but without secondary lobes

  6. Disadvantage of Binomial Arrays • HPBW increases and hence the directivity decreases. • For design of a large array, larger amplitude ratio of sources is required.

  7. Tchebyshev polynomial • Tm(x)=cos(m cos-1x), -1<x<1 • M=0; • To(x)=cos(0)= 1 • T1(x)=cos(cos-1 x)=x • T2(x)=cos(2cos-1 x)=cos(2Y)=2cos2 Y-1 =2x2-1

  8. ………………..(11) The polynomials of equation (10) are called Tchebysceff polynomials which is denoted as Further higher terms can be had from the recursion formula Tchebysceff Polynomials ………………..(12)

More Related