1 / 46

LABORATORY SAFETY AND EQUIPMENT

LABORATORY SAFETY AND EQUIPMENT. LABORATORY SAFETY. While working in the science laboratory, you will have certain important responsibilities that do not apply to other classrooms.

lula
Download Presentation

LABORATORY SAFETY AND EQUIPMENT

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. LABORATORY SAFETY AND EQUIPMENT

  2. LABORATORY SAFETY • While working in the science laboratory, you will have certain important responsibilitiesthat do not apply to other classrooms. • You will be working with materials and apparatus which, if handled carelessly or improperly, have the potential to cause injury or discomfort to someone else as well as yourself.

  3. http://lansce.lanl.gov/training/FST2004/images04/chemicals1.gifhttp://lansce.lanl.gov/training/FST2004/images04/chemicals1.gif

  4. Safety Symbols

  5. 0 Least Serious 4 Most Serious 4 0 NFPA CHEMICAL HAZARD LABEL 4 3 2 Flammable vapor which burns readily Substance is stable

  6. 4 Burns readily. 4 3 W May detonate with heat or ignition. Severe health risk. Avoid water. NFPA CHEMICAL HAZARD LABEL Diborane

  7. 1 Prior to 1996, this section was titled "Reactivity". The name was changed because many people did not understand the distinction between a "reactive hazard" and the "chemical reactivity" of the material. The numeric ratings and their meanings remain unchanged.

  8. This section is used to denote special hazards. There are only two NFPA 704 approved symbols

  9. Laboratory Equipment

  10. 1. Beaker Beakers hold solids or liquids that will not release gases when reacted, or are unlikely to splatter if stirred or heated. Very poor to measure volume with (+/-5%) accuracy Note the size capacity (250 mL in this case)

  11. 2. Erlenmeyer Flask Erlenmeyer flasks hold solids or liquids that may release gases during a reaction or that are likely to splatter if stirred or heated. Note the size

  12. 3. Florence Flask Rarely used in first year chemistry, it is used for the mixing of chemicals. Narrow neck prevents splash exposure.

  13. 4. Graduated Cylinder Others that are smaller may not have “bumpers”, but have reinforced glass. A graduated cylinder is used to measure volumes of liquids – probably your best everyday measuring tool. Note the rubber “bumpers”, and also the size.

  14. 5. Test Tubes 18 x 150 mm Ignition Tube (25 x 200 mm) 13 x 100 mm Test tubes are used to mix chemicals, and also to heat chemicals.

  15. 6. Test Tube Holder A test tube holder is useful for holding a test tube which is too hot to handle. Knowing where to hold this piece of equipment is important.

  16. 7. Test Tube Brushes Test tube brushes are used to clean test tubes and graduated cylinders. Small test tube brush Forcing a large brush into a small test tube will often break the tube. Don’t worry about drying the inside of a test tube. Large test tube brush

  17. 8. Test Tube Racks Test tube racks are for holding and organizing test tubes on the laboratory counter.

  18. 9. Rubber Stoppers Rubber stoppers (also cork) are used to close containers to avoid spillage or contamination. Containers should never be heated when there is a stopper in place.

  19. 10. Well Plates Well plates are used when we want to perform many small scale reactions at one time. It is like having lots of test tubes available at one time.

  20. 11. Watch Glass A watch glass is used to hold a small amount of solid, such as the product of a reaction. Can also be used as a cover for an evaporating dish or beaker.

  21. 12. Stirring Rod The stirring rod is used to: a) manually stir solutions; b) assist in pouring liquids; and c) to transfer a single drop of a solution. Rubber policeman tip is used to remove precipitates. Stir with this end.

  22. 13. Dropper Pipet A dropper pipet is used to transfer a small volume of liquid, usually one drop at a time. On top of each dropper is a “rubber bulb” – never put your mouth on the dropper to provide suction

  23. 14. Funnel A funnel is used to aid in the transfer of liquids from one vessel to another, and will hold filter paper while filtering.

  24. 15. Graduated Pipet A graduated pipet measures and delivers exact volumes of liquids – uses a rubber bulb for suction (not your mouth).

  25. 16. Wash Bottle A wash bottle has a spout that delivers a water stream to a specific area. Distilled water is the only liquid that should be used in a wash bottle Distilled Water During use, keep the bottle upright as shown, since ours have a tube that goes to the bottom of the bottle.

  26. Place item here to mass 17.Electronic Balance • Electronic balances are very accurate, highly dependable, and rugged. • The digital display makes the mass value very easy to determine. “On” button “Tare” button “Off” button

  27. 18.Spatula Spatulas are used to dispense solid chemicals from their containers. Chemicals should never be transferred with your bare hands.

  28. 19.Beaker Tongs Beaker tongs are used to move beakers containing hot liquids. Note the rubber coating to improve grip on the glass beaker - do not hold this in a burner flame.

  29. 20.Burner Burners are used for the heating of nonvolatile liquids and solids. Hot plates will be used to gently heat any flammable chemicals.

  30. 21. Evaporating Dish The evaporating dish is used for heating stable solid compounds and elements, as well as for evaporating nonvolatile solutions.

  31. 22. Crucible and cover Crucibles are used for heating certain solids, particularly metals, to very high temperatures. The cover can be used to contain any smoke particles.

  32. 23. Clay Triangle The clay triangle is used as a support for crucibles when being heated over a lab burner. It can also be used to support a funnel when filtering.

  33. 24. Crucible Tongs For handling hot crucibles; also used to pick up other hot objects - NOT to be used for picking up beakers!

  34. 25. Ringstands Ringstands are a safe and convenient way to perform reactions that require heating using a lab burner. Can also be used as an insulating pad to place hot objects while they cool.

  35. Ringstands and their components26. Ring Clamp Ring clamps connect to a ringstand, and provide a stable, elevated platform for a beaker to be heated. Will also hold a clay triangle and funnel during filtering.

  36. Ringstands and their Components27. Test tube Clamps Test tube clamps are used to secure test tubes, distillation columns, and burets to the ringstand.

  37. Ringstands and their Components28. Double Buret Clamps Double Buret clamps are used to secure burets (long graduated tubes used in titrations) to the ringstand.

  38. Ringstands and their Components29. Wire Gauze Wire gauze sits on the iron ring to provide a place to stand a beaker. On older wire gauze, the white material was asbestos – currently it is a ceramic.

  39. 30. Lighter These strikers are used to light lab burners. The flints on strikers are expensive. Do not operate the striker repeatedly just to see the sparks!

  40. 31. Weighing Paper Used to measure small amount of solids. Never place chemicals directly onto the balance.

  41. 32. Hot Plates Used to “gently” heat liquids. We can’t regulate the heat In ours. To avoid spills, remove beaker or flask using tongs and place it on the lab desk.

  42. 33. Triple Beam Balance Used for weighing solids, liquids and powders.

  43. 34. Mortar and pestle Used to grind solids into powders

More Related