1 / 15

A First Pass at Modeling Horn 3

A First Pass at Modeling Horn 3. L. Bartoszek Bartoszek Engineering 12/10/04. Need z dimension for placement of striplines through support module. Elevation view of horn 3 with 183 cm tall man for scale. Isometric view looking downstream.

lydia-olsen
Download Presentation

A First Pass at Modeling Horn 3

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. A First Pass at ModelingHorn 3 L. Bartoszek Bartoszek Engineering 12/10/04

  2. Need z dimension for placement of striplines through support module Elevation view of horn 3 with 183 cm tall man for scale

  3. Isometric view looking downstream

  4. Need this dimension too to fix the ear and stripline design View looking downstream along axis of horn

  5. View looking upstream along axis of horn

  6. Isometric view looking upstream

  7. Close-up of upstream end of horn 3 52 M16 ceramic washer assemblies 128 M10 bolts I did not put in all the bolts holding the ears to the horn yet

  8. Horn without stripline or ears

  9. Outer Conductor rendered transparent

  10. Inner Conductor fully welded

  11. Man next to ceramic ring

  12. Concern about previous picture • That is the largest ceramic ring I’ve ever seen. • I recommend making a part drawing for it and sending it out to Japanese and US ceramics vendors for their comments. • Handling this ring will require some special tooling to avoid cracking from bending stress.

  13. Coss-section showing approximate pattern of vee nozzles

  14. Concern about previous picture • The standard 110° “vee” spray nozzles may be too diffuse to get good heat transfer at the small radius of the center of the horn (“neck”). • May need sharper, more circular nozzles to direct spray at the neck of the inner conductor.

  15. Conclusions • Need more dimensions to finalize the stripline and ear designs • This horn is the original geometry Ichikawa sent me, not reduced by 90 mm (to be able to make flanges from available stock). • Large flanges may be made by forged rings • I am slightly concerned about the relatively thin wall of the outer conductor leading to large tolerances/deflections from circularity • Flanges add stiffness and may keep OC round—only analysis will tell.

More Related