1 / 11

Triten Range Of Products

Triten Range Of Products. Fabrication Guide. Cutting. Four Methods Of Cutting. Plasma Arc Water Jet Carbon Arc Abrasive Saw NOT by oxy-gas. Plasma Arc Cutting. Recommended method. Material can be cut with hand-held model (inexpensive) Plates can be cut from either side

mignon
Download Presentation

Triten Range Of Products

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Triten Range Of Products Fabrication Guide

  2. Cutting

  3. Four Methods Of Cutting • Plasma Arc • Water Jet • Carbon Arc • Abrasive Saw • NOT by oxy-gas

  4. Plasma Arc Cutting • Recommended method. • Material can be cut with hand-held model (inexpensive) • Plates can be cut from either side • Consider plasma arc taper • High definition plasma for greater precision • Angled torch for countersunk holes

  5. Cold Forming

  6. Material can be pressed or rolled with care

  7. Cold Forming • Rolling always in the same direction as the overlay beads. • Convex recommended • Concave with great care • Pressing always with a radiused tool, never with a “knife”

  8. Fixing Holes

  9. Methods of attachment • Material cannot be mechanically drilled or countersunk using traditional methods • Either : • Plug welding • Stud Welding • Countersunk bolts • Pre-machined inserts

  10. Fixing Holes • Direct plasma arc piercing gives a perfectly acceptable hole quality for most applications • A machined insert can be welded in place but is often a more expensive method

  11. For further information, refer to the Triten Fabrication Guide

More Related