1 / 27

Introduction to

Introduction to. ARIA IP - 60. Anton Hattingh . Content. System overview Connection diagram System Recourses Connections Hardware Features. System overview. Hybrid telephone system with 12 analog PSTN’s & 48 ext. Caller ID service for CO line & SLT

nissim-wall
Download Presentation

Introduction to

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Introduction to ARIA IP - 60 Anton Hattingh

  2. Content • System overview • Connection diagram • System Recourses • Connections • Hardware • Features

  3. System overview • Hybrid telephone system with 12 analog PSTN’s • & 48 ext. • Caller ID service for CO line & SLT • Conference, SMDR, LCR, Call duration control • Collect call barring, Mobile extension • Other services for enterprise communications • - Alarm detection • - External door phone control • - External paging interface, • - External music source interface

  4. General connection diagram

  5. System Resources 1/2

  6. System Resources 2/2

  7. MBU connectors and LED Status LED LD1 : System running indication LD2-4 : S/W task indication SW1 : Default ON Pole1 : reserved Pole2 : system trace on Pole3 : reserved Pole4 : system backup SW2 : Backup battery ON for protection ※ Available Option: 1. CN2 : E1HB8, CHB308, CSB316 or SLIB8 2. CN4 : MODU 3. CN5 : VMIU or AAFU 4. CN14: VOIB 5. CN9 & CN10: CMU50PR or CMU12PR

  8. System Connections BKSU Only BKSU CO# : Loop start CO Port STA# : Hybrid Port DKT# : DKTU Only Port SLT# : SLT Only Port RJ-11 1: N/A 2: DKT-Tip 3: SLT-Tip or CO-Tip 4: SLT-Ring or CO-Ring 5: DKT-Ring 6: N/A EKSU

  9. Connector Pin-out 1/3 MBU (CO) MBU (Extension) DKT ONLY MBU (Hybrid) NOTE—When installing DKT or SLT on Hybrid Ports, (MJ2-2,3,4,5,6,7,8), keep the above pin assignment. Otherwise the DKT or SLT will not operate normally.

  10. Connector Pin-out 2/3 TERMINAL DKT TERMINAL SLT

  11. Connector Pin-out 3/3 CN13 Pin Assignment (Relay Contact) MJ3 Pin Assignment (LAN)

  12. Terminal/SLT Cabling Distance

  13. Expansion Card CHB308 CO Line and Hybrid Board (3 CO + 8 HYB) • External. • Provides 3 circuits Loop start CO line interface. • DTMF or pulse signaling to line • Loop current detection • FSK & DTMF CID detection. • Call progress tone detections • Internal. • Provides 8 digital Stations or 8 SLT station circuits. • FSK & DTMF CID detection and Generator. • +36V Power Circuit for SLT feeding • SLT feeding Current is 20mA at 900ohm loop impedance.

  14. Expansion Card CSB 316 CO Line and SLT Board (3 CO + 16 SLT) • External. • Provides 3 circuits Loop start CO line interface. • DTMF or pulse signaling to line • Loop current detection • FSK & DTMF CID detection. • Call progress tone detections. • Internal. • Provides 16 SLT station circuits. • FSK & DTMF CID detection and Generator. • +36V Power Circuit for SLT feeding • SLT feeding Current is 20mA at 900ohm loop impedance.

  15. Expansion Card SLIB 8 SLT Board (8 SLT’s) • Internal. • Provides 8 SLT station circuits. • FSK & DTMF CID detection and Generator. • +36V Power Circuit for SLT feeding • SLT feeding Current is 20mA at 900ohm loop impedance.

  16. Expansion Card E1HB8 E1 Digital trunk & 8 Hybrid • CN5 on the MBU, but not on the EMBU • E1 digital trunk: maximum 30 CO lines at the same time • 8 Hybrid ports that provide DKT or SLT connection • 2.048Mbps E1 line as CAS(Channel Associated Signaling) • HDB3 CODE • DID, DOD, and TIE according to each country’s specifications • Pulse dialing, DTMF dialing, and MFC-R2 signaling(30 channels at the same time) • SLU8(Single Line Interface Unit: 8 ports • CN6, CN7 on the E1HB8 • +36V power circuit for SLT feeding • Single Line Interface circuit: 8 EA

  17. Add on board MODU Modem function board MODEM function board MODU provides analogue modem connection. MODU should be installed on the CN4 Supports Bell, ITU-T, V.34, V.32BIS, V.90 Protocol 300bps up to 33Kbps speed rate Automatic rate negotiation

  18. Add on board VMIU Voice Mail Interface Unit • VMIU provides 4 channel Record/Play • VMIU provides Time & System prompt • All message are saved in Flash memory • Max record time • - Prompt : 8 Min. • - System greeting : 24 Min • - User record time : 99 Min • Max. Number of User Voice Message: 800ea • Note : User Greeting does not lost by system power off or reset • because of this message is stored in FLASH memory

  19. Add on board AAFU Auto Attendant Function Unit • AAFU provides 4 channel Record/Play • AAFU provides Time & System prompt • All message are saved in Flash memory • Max record time • - Prompt : 8 Min. • - System greeting : 24 Min • - User record time : 9 Min • Max. Number of User Voice Message: 800ea • Note : User Greeting does not lost by system power off or reset • because of this message is stored in FLASH memory

  20. Add on board VOIB & VOIU Voice over Internet Protocol Interface board • VOIB can be installed on the basic MBU • Provides the Ethernet interface for S/W applications and VoIP features . • Optional VoIP daughter board.(VOIU) • Maximum Capacity: 8 channels • -VOIB provides four(4) VoIP channels. • -VOIU provides four(4) VoIP channels.

  21. Add on board CMP50PR & CMU12PR Call Metering & Polarity Reversal Detection unit 50Hz and 12Hz • CMU50PR (Call Metering-50 Hz & Polarity Reversal Detection unit) • Provides 3 channels Call Metering detection for 50Hz • Provides 3 channels of Polarity Reversal Detection • It can be installed on the MBU, EMBU, CHB308 or CSB316 • CMU12PR(Call Metering-12KHz & Polarity Reversal Detection unit) • Provides 3 channels Call Metering detection for 12 KHz or 16Khz • Provides 3 channels of Polarity Reversal • It can be installed on the MBU, EMBU, CHB308 or CSB316

  22. Proprietary Terminals LDP-7224D LDP-7208D LDP-7248DSS LDP-Door phone Not Compatible with OptiCon IP and GDK Systems.

  23. IP Terminals LIP-7024LD LIP-7024D LIP-7016D LIP-7008D

  24. Maintenance Digital Terminal Admin Data Network Maintenance Console Off-site (Remote) Maintenance In-site maintenance PSTN Dial-up Connection On-site & Off site maintenance through RS-232C, Ethernet, Modem On line PC Admin : DB up/download, Diagnostics, S/W upgrade, PC Admin Off line PC Admin (PC Admin Pro) Speed Editor for system speed dial User level admin program – adjustable level program

  25. Voice Mail / Auto Attendant Optional Voice Mail and Auto-Attendant Auto-Attendant : 4 channels / 10 min recording / 25 min system greeting Voice Mail SMS Notification to virtual extension (mobile extension) 4 ch. / Max. 100 min recording time/ 25 min greeting / 800 user message recording Max. 100 system greetings / Max. 25 min

  26. Networking Business models for SIP operator / Nortel IP platform SIP / H.323 proxy registration ARIA IP – 60 Voice Networking

  27. Questions?

More Related