How To Take Care of Under Sink Filtration System With Filter Systems Australia

1. HOW TO TAKE CARE OF UNDER SINK FILTRATION SYSTEM WITH FILTER SYSTEMS AUSTRALIA

2. Many households are installing water filters to assure they have clean drinking and cooking water. A popular under sink filtration system option for homes is the under sink water filter. It takes up space in the cabinet under the sink but is still conveniently out of the way. Like all filter systems, it will require occasional maintenance, and replacing the filter is a simple procedure says filter systems Australia

3. Gather Your Supplies You do not need many tools. A filter wrench is recommended by filter systems Australia to make removing the canister housings easy. The housings can be removed by hand or with another tool if a filter wrench is not available. Towels or something else absorbent is also recommended to wipe up any water that drips. New O-rings may be needed, so it is good to have those on hand as well. You will also need a pressure gauge and an air pump of some sort. A bicycle pump will work fine. Of course, you will also need your under sink water filter.

4. Turn Off the Water Supply Before removing any parts, turn off any valves that allow water to flow. Start with the valve that supplies water to the cabinet. If you have a tank, turn off the tank valve next. Also turn off any valves on the lines or pipe that connects your filter systems Australia.

5. Bleed the Lines Next, bleed the lines to reduce water pressure and let out as much water as you can. The easy way to do this is to turn on the faucet that connects to the water system and let the water flow out. Turn the faucet back off after the water stops flowing.

6. Change the Sediment Filter If you have multiple cartridges in your system, the first cartridge is the sediment filter. Turn the cartridge housing to the left to loosen the housing. Remove the housing carefully since there will still be some water inside. Remove the sediment filter and pour out the remaining water. Rinse the housing if there is still sediment at the bottom. Wash benchtop water purifier , if it still looks dirty. Inspect the O-ring in the top of the housing. Replace it if it is damaged. If it seems dirty, clean it following the manufacturer’s instructions. Place the new sediment filter inside the housing. Screw the housing back onto the bracket. 

7. Change the Carbon Filter Nearly all filters have carbon filters. If you have one filter on your system, it will probably be a carbon filter. If you have more, the filters after the first are likely to be carbon filters. The method for changing the carbon filter is almost the same as changing the sediment filter. Follow the same instructions until you get to the carbon filter removal from filter systems Australia. This time, you will need to inspect the filter cartridge.

8. The filter should have O-rings at each end of the cartridge. Make sure they are not still in the housing. If they are, when you place the new filter in the housing, there will be too many O- rings and the housing and cartridge will not fit. This could make your system leak and not filter correctly. Take note of the orientation of the carbon filter. Some will have a specific up and down end depending on the filter system. If there is an O-ring in the housing, remove it. Inspect the O-ring on the top of the housing like before and pour out the water. Remove the wrapping from the new carbon filter and place it in the housing in the correct orientation. Replace the housing and tighten until snug.

9. DRINK CLEAN, LIVE HEALTHY WWW.OZH2O.COM.AU Q U E E N S L A N D , B R I S B A N E , A U S T R A L I A