Hydro Jetting Cleaning Process In Singapore

1. Instructions for Engineers Working in Pipe Repair and Management Introduction: - An engineer has to perform different sorts of work involving pipes. Those works involve hard work, experience, and knowledge at the same time. Here are some instructions for the safety of man and materials. While installing the butterfly valve, install an extension. This step is taken when installing a valve directly to check the pump or valve. This safety step helps in preventing discs of butterfly value from getting in contact with the check valve. 1. The valve must be installed after completing all the welding operations. In the case of non-adhering to these guidelines, it may be risky. When engineers notice that there is some sort of blockage in the pipes, they do hydro jetting. Hydro jetting is one of the safest and effective ways to clear blockages from pipes. It involves a hose that is capable of exerting force through a continuous stream of water. Any clogs or blockages in the pipe get clear. Only welding is not enough, The engineer has to do flange management so that future leakage could be prevented. However, let the welding cool and then install the valve. 2. While doing welding on the flange, remove the valve first. Doing welding on a flange when the valve is intact is damaging for the valve. In some cases, you may need to change the valve due to this human error. Pipes are meant for transporting many liquid or gaseous items. Water is one of them that go from the water filtering plant to home through pipes. An engineer should be more careful while doing repair work on a water pipeline. After work, they must ensure that no welding residue, scaling, dust, pipe waste is left inside the pipe. Clean the area with utmost care because that water will pollute water and maybe damaging for people drinking piped water. If required, an engineer may perform In-circuit test in pipes.

2. 3. Many times, it is required to blow air to remove any foreign matter in the pipe. In that case, an engineer should install an extension tube in the place of the valve. This helps in preventing damage to the seat ring. Engineers should use neutral detergent or alcohol while removing rust or any waste materials from the pipe. Here, they must ensure that detergent with harmful chemicals is not used in water pipeline repair. Cleaning the surface of the flange is also important before installation. Use compressed air on a flange to clean it. 4. Some flange comes in zinc coating. Here the work of engineers increases. This type of flange is very prone to leakage when proper care has not adhered to. This happens due to the uneven surface of the flange. Valve and mounting flanges properly need an alignment. Engineers should ensure that. Unless it is very much important, engineers should not enter themselves into the pipes. In some circumstances, it is very much needed to enter into the pipe to inspect or repair it. Here, the safety team should ensure that a proper supply of air is maintained. Conclusions: - Despite following the instructions, accidents happen. An engineer may enroll him or her in any online or offline course on first aid. Firstly, use Hydro jetting for any blockage and still, it is not clear; an engineer may enter into the pipe by following proper guidelines. If possible, an oxygen cylinder may be mounted on the back of the engineer that will help in saving lives. Thanking You!!!!!! Visit:- https://petracarbon.com.sg/ Address: Blk 1001 Jalan Bukit Merah #04-01/06, Redhill Industrial Estate, Singapore 159455 Tel: +65 6271 0800 Email: enq_sg@petracarbon.com