1 / 62

Technician Licensing Class T6

2. Amateur Radio Technician Class Element 2. ELEMENT 2 SUB-ELEMENTST1 - FCC Rules, station license responsibilitiesT2 - Control operator dutiesT3 - Operating practicesT4 - Radio and electronic fundamentalsT5 - Station setup and operationT6 - Communications modes and methodsT7 - Special opera

pierce
Download Presentation

Technician Licensing Class T6

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

    1. Technician Licensing Class “T6” Presented by the Plano Texas Stake Plano, Texas January 20, 2007

    2. 2 Amateur Radio Technician Class Element 2 ELEMENT 2 SUB-ELEMENTS T1 - FCC Rules, station license responsibilities T2 - Control operator duties T3 - Operating practices T4 - Radio and electronic fundamentals T5 - Station setup and operation T6 - Communications modes and methods T7 - Special operations T8 - Emergency and Public Service Communications T9 - Radio waves, propagation, and antennas T0 - Electrical and RF Safety

    3. Communications modes and methods T6A Modulation modes, descriptions and bandwidth (AM, FM, SSB)

    4. 4 Communications modes and methods T6A Modulation modes, descriptions and bandwidth (AM, FM, SSB) (cont) Phone transmissions are voice transmissions by radio. Single sideband (SSB) is a form of amplitude modulation.

    6. 6 Amplitude Modulation This is the appearance of an AM signal on a spectrum scope. There is a carrier in the center that uses power but contains no information (it can be used for tuning). Each of the two sidebands (upper and lower) are identical but inverted. HF amateur communications are generally on a single sideband (SSB) by suppressing the carrier and opposite sideband. This is more efficient by using less bandwidth and power is not wasted transmitting a dead carrier and duplicate sideband. Because of radio design simplicity, the convention has been to use lower sideband (LSB) below 14 MHz and upper sideband (USB) above 14 MHz. This is the appearance of an AM signal on a spectrum scope. There is a carrier in the center that uses power but contains no information (it can be used for tuning). Each of the two sidebands (upper and lower) are identical but inverted. HF amateur communications are generally on a single sideband (SSB) by suppressing the carrier and opposite sideband. This is more efficient by using less bandwidth and power is not wasted transmitting a dead carrier and duplicate sideband. Because of radio design simplicity, the convention has been to use lower sideband (LSB) below 14 MHz and upper sideband (USB) above 14 MHz.

    7. 7 AM and SSB

    8. 8 Communications modes and methods T6A Modulation modes, descriptions and bandwidth (AM, FM, SSB) (cont) Upper sideband is normally used for VHF and UHF SSB communications. The primary advantage of single sideband over FM for voice transmissions is that SSB signals use much less bandwidth than FM signals.

    9. 9 Communications modes and methods T6A Modulation modes, descriptions and bandwidth (AM, FM, SSB) (cont) Single sideband (SSB) voice modulation is most often used for long distance and weak signal contacts on the VHF and UHF bands. Frequency Modulation (FM) is most commonly used for VHF and UHF voice repeaters. The emission type, CW, has the narrowest bandwidth

    11. 11 Communications modes and methods T6A Modulation modes, descriptions and bandwidth (AM, FM, SSB) (cont) The approximate bandwidth of a single-sideband voice signal is between 2 and 3 kHz. The approximate bandwidth of a frequency-modulated voice signal is between 5 and 15 kHz. The normal bandwidth required for a conventional fast-scan TV transmission using combined video and audio on the 70-centimeter band is about 6 MHz.

    12. 12 Communications modes and methods T6B Voice communications, EchoLink and IRLP Information is transmitted between stations via the Internet using Echolink. EchoLink allows computer-to-radio linking for voice transmission. Any licensed amateur radio operator may operate on the Echolink system.

    13. 13 Echolink model

    14. Echolink screen shot

    15. 15 Communications modes and methods T6B Voice communications, EchoLink and IRLP (cont) If you hear a brief tone and then a station from Russia calling CQ on a 2-meter repeater you are listening to an Internet linked DX station. Voice over Internet Protocol is the method used to transfer data by IRLP. IRLP is a method of linking between two or more amateur stations using the Internet.

    16. 16 Communications modes and methods T6B Voice communications, EchoLink and IRLP (cont) You might find a list of active nodes using VoIP in a repeater directory or the Internet. When using a portable transceiver you select a specific IRLP node by using the keypad to transmit the IRLP node numbers. Echolink and IRLP have in common: Voice over Internet Protocol technology.

    17. A typical IRLP Node

    18. 18 Communications modes and methods T6C Packet Radio is an example of a digital communications method. Point-to-point digital message forwarding emission mode may be used by a Technician class operator in the 219 - 220 MHz frequency range. Phase Shift Keying (PSK) PSK31 is a low-rate data transmission mode that works well in noisy conditions.

    19. 19 Communications modes and methods T6C Non-voice communications - image communications, data, CW, packet, PSK31, Morse code techniques, Q signals (cont) Automatic Position Reporting System (APRS) A global positioning system receiver is required along with your normal radio for sending automatic location reports. A standard fast scan color television signal transmission is indicated by the term NTSC.

    20. 20 Communications modes and methods T6C Non-voice communications - image communications, data, CW, packet, PSK31, Morse code techniques, Q signals (cont) Any sending speed at which you can reliably receive is recommended when using Morse code. A practical reason for being able to copy CW when using repeaters is to recognize a repeater ID sent in Morse code.

    21. 21 Communications modes and methods T6C Non-voice communications - image communications, data, CW, packet, PSK31, Morse code techniques, Q signals (cont) QRM is the "Q" signal used to indicate that you are receiving interference from other stations. QSY is the "Q" signal used to indicate that you are changing frequency.

    22. 22 Q-Signals Something is causing interference I am troubled by static/noise. I am running low power. I am going off the air. Who is calling me? Your signal is fading. I received the message. I will communicate with ________ directly. I am changing frequency to _____. My location is _______.

    23. 23 Take Aways Connect radio stations to the Internet…Gateway Phone is voice transmission SSB a form of AM USB normally used for VHF & UHF SSB SSB advantage over FM…less bandwidth SSB used for long distance and weak signal contacts on VHF/UHF

    24. 24 Take Aways (cont) FM most common on VHF/UHF repeaters CW has narrowest bandwidth Bandwidth of SSB… 2-3 kHz Bandwidth of FM…5-15 kHz Bandwidth of Fast-scan TV on 70-centimeter … 6 mHz

    25. 25 Take Aways (cont) Echolink uses the Internet Echolink allows computer-to-radio linking for voice Any licensed amateur can use Echolink Echolink & IRLP have VoIP in common Hear a tone and CQ on 2-meter repeater… Internet linked DX station

    26. 26 Take Aways (cont) VoIP method for data transfer by IRLP IRLP links two or more stations using the Internet Active nodes using VoIP listed in repeater directory or on Internet Select IRLP node with keypad Standard fast color TV…NTSC

    27. 27 Take Aways (cont) Packet Radio is digital communications 219-220 mHz for Point-to-point digital message forwarding PSK … Phase Shift Keying PSK31 low-rate data mode that works well in noisy conditions

    28. 28 Take Aways (cont) APRS … Automatic Position Reporting System A GPS receiver needed for APRS Send at speed you can reliably receive Copy CW to recognize ID sent in Morse code QRM … receiving interference QSY … Change frequency

    29. Element 2 Technician Class Question Pool T6

    30. 30 T6A01 What are phone transmissions? The use of telephones to set up an amateur radio contact A phone patch between amateur radio and the telephone system Voice transmissions by radio Placing the telephone handset near a radio transceiver's microphone and speaker to relay a telephone call

    31. 31 T6A02 Which of the following is a form of amplitude modulation? Frequency modulation Phase modulation Single sideband Phase shift keying

    32. 32 T6A03 What name is given to an amateur radio station that is used to connect other amateur stations to the Internet? A gateway A repeater A digipeater A beacon station

    33. 33 T6A04 Which type of voice modulation is most often used for long distance and weak signal contacts on the VHF and UHF bands? FM AM SSB PM

    34. 34 T6A05 Which type of modulation is most commonly used for VHF and UHF voice repeaters? AM SSB PSK FM

    35. 35 T6A06 Which emission type has the narrowest bandwidth? FM voice SSB voice CW Slow-scan TV

    36. 36 T6A07 Which sideband is normally used for VHF and UHF SSB communications? Upper sideband Lower sideband Suppressed sideband Inverted sideband

    37. 37 T6A08 What is the primary advantage of single sideband over FM for voice transmissions? SSB signals are easier to tune in than FM signals SSB signals are less likely to be bothered by noise interference than FM signals. SSB signals use much less bandwidth than FM signals SSB signals have no advantages at all in comparison to other modes.

    38. 38 T6A09 What is the approximate bandwidth of a single-sideband voice signal? 1 kHz 2 kHz Between 3 and 6 kHz Between 2 and 3 kHz

    39. 39 T6A10 What is the approximate bandwidth of a frequency-modulated voice signal? Less than 500 Hz About 150 kHz Between 5 and 15 kHz More than 30 kHz

    40. 40 T6A11 What is the normal bandwidth required for a conventional fast-scan TV transmission using combined video and audio on the 70-centimeter band? More than 10 MHz About 6 MHz About 3 MHz About 1 MHz

    41. 41 T6B01 How is information transmitted between stations using Echolink? APRS PSK31 Internet Atmospheric ducting

    42. 42 T6B02 What does the abbreviation IRLP mean? Internet Radio Linking Project Internet Relay Language Protocol International Repeater Linking Project International Radio Linking Project

    43. 43 T6B03 Who may operate on the Echolink system? Only club stations Any licensed amateur radio operator Technician class licensed amateur radio operators only Any person, licensed or not, who is registered with the Echolink system

    44. 44 T6B04 What technology do Echolink and IRLP have in common? Voice over Internet protocol Ionospheric propagation AC power lines PSK31

    45. 45 T6B05 What method is used to transfer data by IRLP? VHF Packet radio PSK31 Voice over Internet protocol None of these answers are correct

    46. 46 T6B06 What does the term IRLP describe? A method of encrypting data A method of linking between two or more amateur stations using the Internet A low powered radio using infra-red frequencies An international logging program.

    47. 47 T6B07 Which one of the following allows computer-to-radio linking for voice transmission? Grid modulation EchoLink AMTOR Multiplex

    48. 48 T6B08 What are you listening to if you hear a brief tone and then a station from Russia calling CQ on a 2-meter repeater? An ionospheric band opening on VHF A prohibited transmission An Internet linked DX station None of these answers are correct

    49. 49 T6B10 Where might you find a list of active nodes using VoIP? The FCC Rulebook From your local emergency coordinator A repeater directory or the Internet The local repeater frequency coordinator

    50. 50 T6B11 When using a portable transceiver how do you select a specific IRLP node? Choose a specific CTCSS tone Choose the correct DSC tone Access the repeater autopatch Use the keypad to transmit the IRLP node numbers

    51. 51 T6C01 Which of the following is an example of a digital communications method? Single sideband voice Amateur television FM voice Packet radio

    52. 52 T6C02 What does the term APRS mean? Automatic Position Reporting System Associated Public Radio Station Auto Planning Radio Set-up Advanced Polar Radio System

    53. 53 T6C03 What item is required along with your normal radio for sending automatic location reports? A connection to the vehicle speedometer A connection to a WWV receiver A connection to a broadcast FM sub-carrier receiver A global positioning system receiver

    54. 54 T6C04 What type of transmission is indicated by the term NTSC? A Normal Transmission mode in Static Circuit A special mode for earth satellite uplink A standard fast scan color television signal A frame compression scheme for TV signal

    55. 55 T6C05 What emission mode may be used by a Technician class operator in the 219 - 220 MHz frequency range? Slow-scan television Point-to-point digital message forwarding FM voice Fast-scan television

    56. 56 T6C06 What does the abbreviation PSK mean? Pulse Shift Keying Phase Shift Keying Packet Short Keying Phased Slide Keying

    57. 57 T6C07 What is PSK31? A high-rate data transmission mode used to transmit files A method of reducing noise interference to FM signals A type of television signal A low-rate data transmission mode that works well in noisy conditions

    58. 58 T6C08 What sending speed is recommended when using Morse code? Only speeds below five WPM The highest speed your keyer will operate Any speed at which you can reliably receive The highest speed at which you can control the keyer

    59. 59 T6C09 What is a practical reason for being able to copy CW when using repeaters? To send and receive messages others cannot overhear To conform with FCC licensing requirements To decode packet radio transmissions To recognize a repeater ID sent in Morse code

    60. 60 T6C10 What is the "Q" signal used to indicate that you are receiving interference from other stations? QRM QRN QTH QSB

    61. 61 T6C11 What is the "Q" signal used to indicate that you are changing frequency? QRU QSY QSL QRZ

    62. 62 Practice exams on the Internet HTTP://www.QRZ.Com/p/testing.pl HTTP://www.W8MHB.Com/Exam HTTP://www.AA9PW.Com/Radio

More Related