1 / 2

RetroGame

Retro Game. 7805T = 5-volt regulator R1 – R7 & R17 = 100 Ω (brown, black, brown) R8 – R10 = 10 k Ω (brown, black, orange) R12 – R16 = 1 k Ω (brown, black, red) C1 = 10 pF – OK to leave out C2 = 1 μ F Q1 – Q5 = 2N2907 or 2N3906 IC1 = PIC16C622A or 16C620P IC2 = 74LS374N Speaker

quintessa-knox
Download Presentation

RetroGame

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Retro Game • 7805T = 5-volt regulator • R1 – R7 & R17 = 100 Ω (brown, black, brown) • R8 – R10 = 10 k Ω (brown, black, orange) • R12 – R16 = 1 k Ω (brown, black, red) • C1 = 10 pF – OK to leave out • C2 = 1 μF • Q1 – Q5 = 2N2907 or 2N3906 • IC1 = PIC16C622A or 16C620P • IC2 = 74LS374N • Speaker • 2 push-buttons • Battery clip and holder • 2-pin battery connector • two 7-pin sockets for display • 5x7 LED display • 2 small screws and nuts Use Socket Flat top of switch Optional Socket Parts List Pin 1 Pin 1 Building the RetroGame is pretty easy if you’ve had soldering experience. This manual points out some of the more important details. May be omitted 7-pin sockets (hidden) Hints RetroGame Special thanks to: • Be SURE to use an IC socket for IC1 (the PIC processor). There will be other RetroGames and you will need to replace this part to play them. • Be CAREFUL about the direction the ICs are mounted. Line up the notch on the board with the socket or IC. • Use the 7-pin sockets to mount the display. It needs to be mounted higher than the screws holding the battery holder. • The pins on the transistors need to be shaped into a triangle and mounted on the board with the flat side facing the display. • Unfold this manual to see a picture of mounted transistors and more hints. For sponsoring the PCBs! Construction Notes RetroGame December 2006 – EJR eric@rothfus.com

  2. RetroGame v1.1 • Make sure that the flat side of the push-buttons is facing the top of the board. • The bottom of the little speaker has + (plus) and – (minus) pins. Put the + pin in the hole closest to R17. • The display can be inserted in either orientation. There’s no “top” or “bottom” of the display. • Insert the screws for the battery holder from the bottom of the board. This makes the battery fit better. • Insert the battery clip through the hole in the bottom of the board, and tie a loose knot to keep it from falling out. More Hints

More Related