1769 IQ32

1. Get 1769 IQ32 Parts & Know Their Installation Process in Easiest Way Looking to expand your PLC setup while maximizing space in close-fitting settings? Select this 32- channel digital input module from Roc Automation's Allen Bradley range. Its solid dimensions of 118mm (h), 52.5mm (w) and 87mm (d) build it a consistent choice in busy panels. This 1769 IQ32 ControlLogix Modules Comprise Motion Control, Digital, Analog, Specialty I/O Module. Usage this module to achieve PLC automation tasks &enhance efficiency in industrial atmospheres. All The Necessary Parts That Describe the IQ32 Module: bus lever(with locking function), upper and lower panel mounting tab, I/O diagnostic LEDs, movable bus connector with female pins, module door with terminal identification label, stationary bus connector with male pins, upper and lower tongue-and-groove slots, nameplate label, upper and lower DIN rail latch, MIL-C-83503 connector, write-on label (user ID tag), How To Do Compactlogix 1769 Module Installation - Compact I/O is appropriate for use in any industrial situation when it can be installed in accord with these directions. Specifically, this apparatus is planned for use in clean, dry atmospheres and to routes not exceeding Over Voltage Category. Know How to Prevent Electrostatic Discharge– As Electrostatic discharge can harm integrated circuits or semiconductor device if you touch bus connecter pins. Follow these instructions when you handle this module: –Touch a grounded entity to discharge stationary potential. –Put on an appropriate wrist-belt grounding device. –Don’t touch circuit machineries inside the module. –Don’t touch this bus connector/connector pins. –If available, usage a stationary-safe work station. –When not in usage, keep this module in its static-safeguard box Roc Automation is the perfect Automation parts store that has a different variety in I/O modules, PLCs, its components etc. Perform System Assembly: The module can be linked to the controller or an end-to-end I/O module before or aftermounting. To work with a system that is previously mounted, see Replacementof a Single Modulewithin a System. TheseFollowing Procedure Displays You How to Assemble This Compact I/O System- 1. First Disconnect power. 2. Check the bus lever of this module to be mounted is in the unlocked (fully right) place.

2. 3. Use the upper & lower tongue-&-groove slits to protect the modules together. 4. Change the module back along the tongue-&-groove holes until the bus connecters line up with each other. 5. Now Push the bus lever back slightly to clear the aligning tab. You can use your fingers or asmall screw driver. 6. To permit communication between the controller and the module, change the bus lever completely to the left until it clicks. Make sure it is locked definitely in place. Note: When assigning I/O modules, it is very significant that the bus connectorsare strongly locked together to confirm proper electrical connection. 7. Connect an end lid terminator to the last module in the system by using thetongue-&-groove slots as before. 8. Latch the end cap bus terminator Important: A 1769-ECL or 1769-ECR or right or left end cap should be used to terminatethe end of the serial communication bus. To make an order, pay a visit to ROC Automation