1 / 18

ISIS Related Issues for MICE

ISIS Related Issues for MICE. Adam Dobbs Proton Accelerator Development Meeting, RAL 24 th March 2011. Contents. Introduction to MICE Purpose Ionisation Cooling The Cooling Channel MICE in ISIS and the Beamline ISIS beam loss measurement ISIS beam loss and MICE particle rate

sadah
Download Presentation

ISIS Related Issues for MICE

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. ISIS Related Issues for MICE Adam Dobbs Proton Accelerator Development Meeting, RAL 24th March 2011 A. Dobbs

  2. Contents • Introduction to MICE • Purpose • Ionisation Cooling • The Cooling Channel • MICE in ISIS and the Beamline • ISIS beam loss measurement • ISIS beam loss and MICE particle rate • Beam loss and target depth • Beam loss and particle rate • Beam loss and muon rate • Conclusion A. Dobbs

  3. Muon Ionisation Cooling Experiment • Purpose: investigate the feasibility of ionisation cooling, for application to a future Neutrino Factory or Muon Collider. • Neutrino Factory → Precision measurements of neutrino oscillations • Muon Collider → Multi-TeV lepton – anti-lepton collisions A. Dobbs

  4. Ionisation Cooling - Why • An NF muon beam requires cooling (emittance reduction) in order to fit efficiently within the acceptance of downstream acceleration components • An MC also requires small interaction points to increase luminosity • Muon lifetime of 2.2μs to fast to permit traditional cooling techniques → ionisation cooling A. Dobbs

  5. Ionisation Cooling - How • Pass the beam through an absorber e.g. liquid hydrogen, lithium hydride • The particle beam ionises the medium, the beam particles losing energy and momentum in all directions • Re-accelerate the beam in the beamline direction (z) only, using a radio frequency electric field v LiH2 RF v v A. Dobbs

  6. MICE Step VI A. Dobbs

  7. MICE in ISIS and the Beamline A. Dobbs

  8. The MICE target • A 24 coil stator is used to drive a shuttle, consisting of a titanium shaft upon which are mounted permanent magnets to couple to the field produced by the stator • The lower end of the shaft takes the form of a hollow cylinder, which is pulsed into the ISIS beam by the stator • Upper and lower bearings are used to maintain the transverse position of the shaft. A. Dobbs

  9. ISIS Beam loss • 39 argon gas ionisation chambers around the ring • Use the summed signal of the four sector 7 BLMs, integrate over the whole 10ms ISIS cycle (V.ms) • Slightly different gauge used than ISIS (smaller by ∼ 1/3 ) Increased beam loss levels raise the concerns over machine activation levels inhibiting hands-on maintenance A. Dobbs

  10. Beam Loss and Target Depth A. Dobbs

  11. Beam Loss and MICE Particle Rate • Linear correlation • Constant offset • Averaged data – few hundred pulses per point • Pion optics A. Dobbs

  12. Beam Loss and MICE Particle Rate Spill-by-spill data (no averaging) -veπ→μ optics • +veπ→μ optics • Still linear A. Dobbs

  13. Beam Loss and MICE Particle Rate Not linear at low beam loss... not to worry, believed to be caused by a mis-configured gate • +veπ→μ optics, “10V study” A. Dobbs

  14. ...but what about Muons? • Use Time-of-Flight to perform Particle Identification • -veπ→μ optics A. Dobbs

  15. Beam Loss and Muon Rate -veπ→μ optics • +veπ→μ optics • Still linear A. Dobbs

  16. Muon Rate Numbers So, depending on MICE optics get a few 10’s of muons per 1ms spill A. Dobbs

  17. Conclusion • The MICE Muon Beamline is functioning well in ISIS, and has been for sometime • Depending on MICE optics, the beamline delivers a few 10’s of muons per 1ms spill that can be used • Desired rate is several hundred “good” muons per 1ms spill • Would probably require beam loss levels that are intolerable to ISIS • Various solutions put forward: • Increased MICE target dip rate • Longer MICE data running to account for lower rates • ISIS beam bump at MICE target • Improved ISIS collimator system A. Dobbs

  18. Appendix I: Run conditions A. Dobbs

More Related