410 likes | 689 Views
Detectable warnings. Copyright 2002, Accessible Design for the Blind Revised 11/02. Tactile warnings are used in a number of countries. Variety of materials but similar surface characteristics Warning surface Dome configuration Directional surface Bar or line configuration.
E N D
Detectable warnings Copyright 2002, Accessible Design for the Blind Revised 11/02
Tactile warnings are used in a number of countries • Variety of materials but similar surface characteristics • Warning surface • Dome configuration • Directional surface • Bar or line configuration
Warning surface Domes
Detectable warning = ‘Stop sign’ • Delineates the location of the edge of the street • Does not designate the best crossing location for a pedestrian who is blind or visually impaired • Does not provide alignment information
Various surfaces have been installed in the public rights-of-way that have not proven to be detectable under foot and with cane
NOT Detectable • Grooves in concrete, parallel or perpendicular to direction of travel
NOT detectable • Bricks, grids, or other textured pavements
Detectable, under foot and with cane Truncated dome pattern and texture
Research on street detection at curb ramps • Two studies confirmed that removal of the curb was problematic for travelers who are blind • 39% of blind travelers did not detect the street and stop when they approached on a curb ramp • Repeating analysis with only the ramps that met ADA requirements, (were lower slope than 1:12), 48% of travelers stepped into the street
Research on effect of DW on individuals with mobility impairments • little effect on safety and negotiability • considered to be safer, more slip resistant, more stable, and to require less effort to negotiate than concrete curb ramps • small minority affected adversely by detectable warnings (full width and depth of the ramp)
Japanese research on dome spacing • Varied sizes and spacing interval between domes (dots). • Three (shown enclosed by the line) were identified as dot tiles on at least 90% of trials.
Different locations may require different materials • New construction or retrofit • Extent of installation project • Traffic and usage of area • Type of location • Heat • Freezing
Snow and ice clearing methods • Chemicals, salt, sand • Brooms • Machines with brushes • Shovels or snowplows
Variety of materials and installation methods • Surface applied/fabricated • Tiles and sheet goods • Applied • Set in concrete • Bricks or pavers • Stamped in concrete
Surface applied/fabricated • Easy for retrofit installation • Installer needs to be adequately trained • Proper surface preparation important • Some products allow reapplication of individual domes, if necessary
Tiles and sheet goods - applied • Epoxy tile, composite material or polyurethane tiles applied to the surface • Combination of glues and screws used to attach • Necessary to use proper glues and installation method for weather conditions
Tiles and sheet goods – set in concrete One manufacturer has developed a tile with ‘fins’ on the bottom to enable easy installation in wet concrete
Bricks or pavers • Set in concrete • Important to minimize joints and settling • Materials of different thickness and consistency • Bricks easily set in ‘parallel’ pattern • Can be hard to cut and set in a curving installation
Stamped in concrete • Inexpensive – no additional materials • Skilled concrete workers required to do uniform stamping on sloped surface • Difficult to get adequate and uniform pressure on a slope • Top of concrete is softest/most fragile
Other possible materials • Metal detectable warnings used in Denmark and Holland