1 / 6

Developing an Attributes List

Developing an Attributes List. Using the answers from your Questions List to develop a list of attributes for the design. Taken from engineering design: a project-based introduction by dym & little.

suki
Download Presentation

Developing an Attributes List

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Developing an Attributes List Using the answers from your Questions List to develop a list of attributes for the design. Taken from engineering design: a project-based introduction by dym & little

  2. An Attributes List contains a list of objectives, constraints, functions, and implementations. • Objectives (or goals) are expressions of the desired attributes and behavior that the client or potential users would like to see in the designed object. • Constraints (or requirements) are restrictions or limitations on a behavior or a value or some other aspect of a designed object’s performance. Government regulations are often a source of design constraints. Requirements are often generated by the client. • Functions are the things a design is supposed to do – the actions that it must perform. • Implementations (or means) are ways of executing the functions that the design must perform that are specified (at least to some degree) at the outset of the design process.

  3. Here is a partial, uncategorized Attributes List for a “safe ladder” design. • Used outdoors on level ground • Used indoors on floors or other smooth surfaces • Could be a stepladder or short extension ladder • Step deflections should be less than 0.05 inches • Should allow a person of medium height to reach/work at levels up to 11 feet • Must support weight of an average worker • Must be safe • Must meet OSHA requirements • Must be portable between job sites • Should be relatively inexpensive • Must not conduct electricity • Should be light

  4. Here is a partial, categorized Attributes List for a “safe ladder” design. • Objectives • Used outdoors on level ground • Used indoors on floors or other smooth surfaces • Should be relatively inexpensive • Should be light • Must be portable between job sites • Constraints • Must be safe • Must meet OSHA requirements • Must not conduct electricity • Step deflections should be less than 0.05 inches • Functions • Should allow a person of medium height to reach/work at levels up to 11 feet • Must support weight of an average worker • Means • Could be a stepladder or short extension ladder

  5. Below are some tips for developing an Attributes List. • Start with a good list of questions. • Use the answers to the questions to begin creating the Attributes List. • You don’t have to categorize the list at the beginning of the process, unless you prefer to start with the categories. • The attributes that can be quantified become the basis for the Design Specifications.

  6. An example of a partial Attributes List for a 2008 BEST robot • Must be less than 24 pounds • Must fit into a 24-inch cube • Able to pick up individual plane parts • Able to assemble plane parts • Able to drive over a 1” x 4” board • Able to close and open switch • Should have zero-radius turn • Should be able to carry a fully-assembled plane • Should be able to lift a fully-assembled plane to a height of at least 36 inches

More Related