1 / 14

S-72.245 Transmission Methods in Telecommunication Systems (4 cr)

S-72.245 Transmission Methods in Telecommunication Systems (4 cr). Review. 25. Filt. Phase detector. VCO. Divide by 10. PLL based frequency synthesizer. Reference signal f in is locked for instance to the fundamental frequency of a crystal oscillator. By adjusting the

tyme
Download Presentation

S-72.245 Transmission Methods in Telecommunication Systems (4 cr)

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. S-72.245 Transmission Methods in Telecommunication Systems (4 cr) Review

  2. 25

  3. Filt. Phase detector VCO Divide by10 PLL based frequency synthesizer Reference signal fin is locked for instance to the fundamental frequency of a crystal oscillator By adjusting the divider different frequencies can be produced whose phase is locked into fin

  4. Detecting DSB using PLL-principle • An important application for PLLs is in synchronization of receiver local oscillator in synchronous detection • In the Costas PLL (below) two phase discriminators are used to: • cancel out DSB modulation x(t) in the driving signal • synchronize the output frequency to the center frequency of the DSB spectra (the suppressed carrier) • to detect the DSB signal PD: phase detector (=multiply+LPF) Costas PLL detector for DSB LPF yields constant (zero) output when loop is locked to carrier Loop drives phase error to zero

  5. PAM Power Spectral Density (PSD) • PSD for PAM can be determined by using a general expression • For uncorrelated message bitsand thereforeon the other hand and Amplitude autocorrelation Total power DC power

  6. PAM Power Spectral Density (PSD) • PSD for PAM can be determined by using a general expression • For uncorrelated message bitsand thereforeon the other hand and Amplitude autocorrelation Total power DC power

  7. Example • For unipolar binary RZ signal: • Assume source bits are equally alike and independent, thus

  8. Equalization: Removing Residual ISI • Consider a tapped delay line equalizer with • Search for the tap gains cNsuch that the output equals zero at sample intervals D except at the decision instant when it should be unity. The output is (think for instance paths c-N, cN or c0)that is sampled at yielding

  9. + Tapped Delay Line: Matrix Representation • At the instant of decision: • That leads into (2N+1)x(2N+1) matrix where (2N+1) tap coefficients can be solved:

  10. Example of Equalization • Read the distorted pulse values into matrix from fig. (a)and the solution is Question: what does thesezeros help because they don’t exist at the sampling instant? Zero forced values

  11. Monitoring Transmission Quality by Eye Diagram Required minimum bandwidth isNyqvist’s sampling theorem: Given an ideal LPF with the bandwidth B it is possible to transmit independent symbols at the rate:

More Related