Plastic Closure Designs 1) Malloy (referenced) 2) GE Design Guide (PDF) Table X or Figure Y

1. Plastic Closure Designs1) Malloy (referenced)2) GE Design Guide (PDF)Table X or Figure Y GE TEC 316 Dr. Lou Reifschneider

2. GE

3. Clamshell Assembly Options Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.45.

4. Self tapping screw must have clearance through boss and then a blind pilot boss. Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.46.

5. Cantilever snap molded with two-plate mold Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.32.

6. CantileverSnap Closure Options Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.14.

7. Deflection sequence for a U-shaped cantilever snap Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.20.

8. Cantilever snaps to hold components: two designs Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.21. Locating feature for cover

9. GE

10. GE

11. GE

12. Schematic of Ultrasonic Welder Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.95.

13. GE

14. GE

15. GE

16. GE

17. GE

18. GE

19. GE

20. GE

21. GE KISS-OFF Vent holes made WITHOUT side action.

22. GE

23. GE

24. GE