1 / 1

Figure 2 Results

Towards Practical Molecular Devices: the Incorporation of a Solid Substrate as an Active Component in Molecular Assemblies. Noel M. O’Boyle , a Wesley R. Browne, a Steve Welter, b Ron T.F. Jukes, b Luisa De Cola, b Colin G. Coates, c John J. McGarvey, c Johannes G. Vos a.

Download Presentation

Figure 2 Results

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Towards Practical Molecular Devices: the Incorporation of a Solid Substrate as an Active Component in Molecular Assemblies Noel M. O’Boyle,a Wesley R. Browne,a Steve Welter,b Ron T.F. Jukes,b Luisa De Cola,b Colin G. Coates,c John J. McGarvey,c Johannes G. Vosa a National Centre for Sensor Research, School of Chemical Sciences, Dublin City University, Dublin 9, Ireland b Molecular Photonics Group, IMC, University of Amsterdam, Nieuwe Achtergracht 166, NL-1018 WV Amsterdam, the Netherlands c Queens University Belfast, School of Chemistry, Belfast BT9 5AG, Northern Ireland Ru(bpy)2(H2dcb) Introduction Ruthenium polypyridyl complexes have been widely used as covalently bound dyes in solar energy devices based on nanocrystalline TiO2. In addition it has been shown that nanocrystalline TiO2 surfaces modified with dinuclear RuOs polypyridyl complexes respond in a uniform manner to irradiation as shown below in Figure 1. Figure 1 In most cases the molecular components have been covalently attached via 4,4’-dicarboxy-2,2’-bipyridine (H2dcb) type ligands. It is generally assumed that in these assemblies injection into the TiO2 surface is enhanced by the fact that the excited state is based on the dcb2- ligand. This assumption is tested here for the model compound [Ru(bpy)2(dcb)2-] (see Figure 2) by the use of deuteriation in combination with emission lifetime measurements and resonance Raman spectroscopy. Deuteriation Scheme 1 Table A Figure 2 Results The emission spectrum and absorption spectra (both steady-state and transient) of [Ru(bpy)2(dcb)2-] are shown in Figure 3 while the emission lifetimes obtained for the partially deuteriated complexes are shown in the Table A. Deuteriation reduces the rate of non-radiative deactivation of the excited state. This leads to increased emission lifetimes provided the excited state is based on the deuteriated ligand. Figure 3 Excited-state resonance Raman measurements (Figure 4) clearly show that the excited state is localised on the dcb2-. Resonances due to the dcb3–• anion radical are observed at 1312 and 1212 cm-1. Figure 4 d6-H2dcb Conclusions Both the variation in emission lifetime as well as the rR spectra observed confirm that the excited state in bpy/dcb2- complexes is dcb2- based. The results clearly indicate that deuteriation is a powerful method for the study of the nature of the excited state in complexes of ruthenium. Acknowledgements This work was supported by Enterprise Ireland and COST D19.

More Related