1 / 6

Making Generic Tray Discussion

Making Generic Tray Discussion. The meeting held at Avago on 2 Feb 2010 and it was discussed between Ding, S H Chan, Vincent (Agavo) and Thomas (Accuratus). The suggestion made during the meeting are as follows: Thomas will list down the issues for the tray.

alexandra-romero
Download Presentation

Making Generic Tray Discussion

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Making Generic Tray Discussion The meeting held at Avago on 2 Feb 2010 and it was discussed between Ding, S H Chan, Vincent (Agavo) and Thomas (Accuratus). The suggestion made during the meeting are as follows: Thomas will list down the issues for the tray. Ambit will check and decide the tolerance of the tray modification. Avago will check the FLT tolerance between the old FLT and new FLT, it is due to there are different between the two parts, although the tolerance control in the drawings are same.

  2. 1. The hole was not mention earlier. 2. It can be added for the new tray.3. The Y dimension for the additional holes will be same as the holes at two sides.

  3. 1. To make the additional cut out. A new mold block need to be made.2. Additional Cost for making the block.3. The Cut out dimension will be recommended as 5.15mm +/- 0.1mm. The final tolerance will confirm by Ambit.

  4. 1. It is almost impossible to make any changes due to the pitch of the FLT Pocket. It will affect the Lens Bonder’s Gripper position.2. Modification of the Laser Making Machine’s track or clamp may be needed.3. Avago and Ambit will need to make the changes.

  5. FLT Drawing

  6. FLT Dimension Tray Dimension Other issueOrientation control1. The FLT dimension is 1.4mm +/-0.05mm per side, which is 2.8mm +/- 0.1 for both side.2. The Tray dimension is 2.6mm +/-0.1mm.3. The actual FLT need to be measured as the Beta FLT can fit in the tray on both side. Orientation Control Tolerance for FLT Orientation Control Tolerance for Tray

More Related