1 / 6

Current tray

1. Overview. New tray. Current tray. Outline﹕62*118 Unit qty: 24ea Material: Acryl+Al. Outline﹕62*118 Unit qty: 50ea Material: Steel. 2. Trial run status. 2.1 Parameters. 2.1 Marking effect.

shoshana-herrera
Download Presentation

Current tray

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. 1. Overview New tray Current tray Outline﹕62*118 Unit qty: 24ea Material: Acryl+Al Outline﹕62*118 Unit qty: 50ea Material: Steel

  2. 2. Trial run status 2.1 Parameters 2.1 Marking effect Due to the guide hole is not same as the current, so we use manual method to finish the sample marking﹐the word location need optimization by re-define the program.

  3. 3. Problems-(1) 57mm 57mm There is no middle guide hole, so machine can not load the jig correctly in current machine normal setting. Need add this hole.

  4. 3. Problems-(2) The unit loss rate is 60% during marking process, the cavity for FLT is a little bigger. Suggestion: To do under-cut as above picture to hold FLT tightened and avoid FLT jumping out of the jig.(The under cut dimension tolerance should be within +0.1/-0mm)

  5. 3. Problems-(3) 2.37mm The edge for clamping is too narrow, hard to index.Need adjust the machine track or clamp.

  6. 4. Attached---current jig

More Related